Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (w/ Multi-display) › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255488 AUDIO AND VISUAL SYSTEM(w/ Multi-display) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/ Multi-display)  Data Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the multi-media module receiver assembly via this circuit.

WIRING DIAGRAM

E329642E02
0.866,0.815 1.213,0.955 0.347,0.140 10 US1- 0.844,1.425 1.212,1.564 0.368,0.140 10 US1+ 5.966,1.425 6.334,1.564 0.368,0.140 10 US1+ 5.966,0.815 6.345,0.955 0.379,0.140 10 US1- 5.966,1.982 6.373,2.121 0.407,0.140 10 USG1 5.782,0.694 6.198,0.834 0.416,0.140 10 2 5.782,1.291 6.160,1.431 0.378,0.140 10 3 5.782,1.892 6.254,2.032 0.472,0.140 10 5 1.349,0.694 1.765,0.834 0.416,0.140 10 2 1.341,1.291 1.719,1.431 0.378,0.140 10 3 3.554,2.085 4.244,2.225 0.689,0.140 10 * 4.033,3.339 4.841,3.517 0.809,0.178 10 *: Shielded 0.261,2.418 0.652,2.583 0.391,0.165 10 t1 0.261,2.583 1.928,3.115 1.668,0.532 10 No. 1 Stereo Jack Adapter Assembly 5.692,2.418 6.102,2.583 0.410,0.165 10 z1 5.692,2.583 6.976,3.115 1.284,0.532 10 Multi-media Module Receiver Assembly 1.095,3.339 3.686,3.485 2.591,0.147 10 : Data Signal (USB Communication Line)

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the z1 multi-media module receiver assembly connector.


b.

Disconnect the t1 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
z1-2 (US1-) - t1-2 (US1-) Always Below 1 Ω
z1-3 (US1+) - t1-3 (US1+) Always Below 1 Ω
z1-2 (US1-) or t1-2 (US1) - Body ground Always 10 kΩ or higher
z1-3 (US1+) or t1-3 (US1+) - Body ground Always 10 kΩ or higher
z1-5 (USG1) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR