Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255497 TOYOTA PARKING ASSIST-SENSOR SYSTEM J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  ECU Power Source Circuit  


DESCRIPTION

This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the TOYOTA parking assist-sensor system, parking assist monitor system (w/ Side Monitor System), side monitor system and wide view front monitor system. When a malfunction occurs in this circuit, each system will be abnormal.

WIRING DIAGRAM

E251391E02
4.789,1.842 5.065,1.998 0.276,0.156 10 F75 4.882,0.469 5.098,0.625 0.216,0.156 10 +B 4.728,0.399 4.849,0.555 0.121,0.156 10 1 4.882,0.831 5.098,0.987 0.216,0.156 10 IG 3.126,0.592 3.867,0.748 0.741,0.156 10 RAD NO. 1 1.503,0.463 2.292,0.619 0.790,0.156 10 from Battery 0.881,0.823 2.287,0.979 1.405,0.156 10 from IG1 NO. 1 Relay 1.241,1.183 2.290,1.339 1.049,0.156 10 from ACC Relay 3.031,0.952 3.948,1.108 0.917,0.156 10 ECU-IG No. 1 3.319,1.312 3.660,1.468 0.342,0.156 10 ACC 4.728,0.761 4.849,0.917 0.121,0.156 10 8 4.882,1.193 5.212,1.349 0.330,0.156 10 ACC 4.728,1.122 4.849,1.278 0.121,0.156 10 9 4.882,1.5 5.300,1.656 0.418,0.156 10 GND1 4.728,1.43 4.849,1.586 0.121,0.156 10 4 4.789,1.989 6.065,2.145 1.276,0.156 10 Parking Assisr ECU

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND)
a.
U166293E02
2.51,0.958 2.708,0.531 2.708,0.531 2.875,0.531 true 1.438,1.323 1.802,1.833 1.802,1.833 1.979,1.833 true 1.292,1.323 1.094,1.833 1.094,1.833 0.885,1.833 true 0.865,0.969 0.677,0.448 0.677,0.448 0.448,0.448 true 1.552,0.333 1.865,0.563 0.313,0.229 10 false F75 2.927,0.458 3.365,0.729 0.438,0.271 10 false GND1 2.01,1.74 2.438,1.958 0.427,0.219 10 false ACC 0.677,1.75 0.865,1.938 0.188,0.188 10 false IG 0.208,0.365 0.406,0.531 0.198,0.167 10 false +B 0.073,0.042 0.323,0.229 0.25,0.188 10 false *a

Disconnect the parking assist ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F75-4 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F75-1 (+B) - F75-4 (GND1) Always 11 to 14 V
F75-8 (IG) - F75-4 (GND1) Engine switch on (IG) 11 to 14 V
F75-9 (ACC) - F75-4 (GND1) Engine switch on (ACC) 11 to 14 V



Text in Illustration
*a Front view of wire harness connector
(to Parking Assist ECU)


OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR