Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255497 TOYOTA PARKING ASSIST-SENSOR SYSTEM J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit is the power source circuit to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E182726E71
4.275,1.931 6.533,2.142 2.258,0.211 10 Clearance Warning ECU Assembly 4.275,1.776 4.570,1.942 0.295,0.165 10 F12 4.897,0.586 5.104,0.755 0.207,0.170 10 IG 4.897,1.286 5.331,1.456 0.434,0.170 10 GND1 4.653,0.464 4.853,0.652 0.200,0.188 10 15 4.653,1.151 4.853,1.339 0.200,0.188 10 17 2.263,0.726 3.271,0.895 1.008,0.170 10 ECU-IG No. 1 0.171,0.574 1.540,0.744 1.369,0.170 10 from IG1 NO. 1 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY- BATTERY AND BODY GROUND)
U166365E02
1.406,1.542 1.208,1.906 1.208,1.906 1.021,1.906 true 1.708,1.542 1.906,1.906 1.906,1.906 2.094,1.906 true 1.604,0.542 1.875,0.719 0.271,0.177 10 false F12 0.146,0.073 0.417,0.25 0.271,0.177 10 false *a 0.802,1.823 1.063,2.01 0.26,0.188 10 false IG 2.167,1.823 2.583,2 0.417,0.177 10 false GND1

a.

Disconnect the clearance warning ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F12-17 (GND1) - Body ground Always Below 1Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F12-15 (IG) - Body ground Engine switch on (IG) 11 to 14 V
F12-15 (IG) - Body ground Engine switch off Below 1 V



Text in Illustration
*a Front view of wire harness connector
(to Clearance Warning ECU Assembly)


OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR