Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255497 TOYOTA PARKING ASSIST-SENSOR SYSTEM J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit is the power source circuit to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E182726E92
4.779,1.966 6.074,2.309 1.295,0.343 10 Clearance Warning ECU Assembly 4.779,1.812 5.935,1.977 1.156,0.165 10 F92 4.897,0.602 5.104,0.771 0.207,0.170 10 IG 4.897,1.298 5.331,1.468 0.434,0.170 10 E 4.692,0.508 4.890,0.696 0.198,0.188 10 1 4.622,1.229 4.819,1.417 0.198,0.188 10 30 2.35,0.761 3.252,0.931 0.902,0.170 10 ECU-IG NO.3 0.286,0.596 1.707,0.765 1.421,0.170 10 from IG NO.2 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY AND BODY GROUND)
a.
U166486E02
0.5,1.021 0.771,1.802 0.771,1.802 0.896,1.802 true 1.76,1.188 2.063,1.865 2.063,1.865 2.219,1.865 true 0.177,0.125 0.375,0.323 0.198,0.198 10 false *a 1.573,0.292 1.927,0.479 0.354,0.188 10 false F92 2.313,1.781 2.615,1.979 0.302,0.198 10 false E 0.969,1.729 1.375,1.927 0.406,0.198 10 false IG

Disconnect the F92 clearance warning ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F92-1 (IG) - Body ground Engine switch off Below 1 V
F92-1 (IG) - Body ground Engine switch on (IG) 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F92-30 (E) - Body ground Always Below 1Ω



Text in Illustration
*a Front view of wire harness connector
(to Clearance Warning ECU Assembly)


OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR