Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255500 CLEARANCE SONAR MAIN SWITCH G

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84490A 1.INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

a.
E245465E04
1.542,1.365 1.542,1.813 true 2.146,1.365 2.146,1.813 true 0.104,0.073 0.365,0.292 0.26,0.219 10 false *a 1.406,1.833 1.792,2.052 0.385,0.219 10 false ECU 2.104,1.823 2.365,2.042 0.26,0.219 10 false IG

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 (IG) - 9 (ECU) Back sonar or clearance sonar switch assembly on Below 1 Ω
6 (IG) - 9 (ECU) Back sonar or clearance sonar switch assembly off 10 kΩ or higher


Text in Illustration
*1 Component without harness connected
(Back Sonar or Clearance Sonar Switch assembly)

If the result is not as specified, replace the back sonar or clearance sonar switch assembly.


b.
E245465E05
1.344,1.375 1.344,1.823 true 2.146,1.375 2.146,1.823 true 0.073,0.063 0.333,0.281 0.26,0.219 10 false *a 1.25,1.844 1.583,2.063 0.333,0.219 10 false IND 2.094,1.854 2.354,2.073 0.26,0.219 10 false IG

Check that the switch indicator.

i.

Apply battery voltage to the blind spot monitor main switch (integration control and panel assembly) and check the operation of the switch as shown in the table below.

OK:
Tester Connection Specified Condition
Battery positive (+) → Terminal 6 (IG)
Battery negative (-) → Terminal 10 (IND)
Illuminates


Text in Illustration
*1 Component without harness connected
(Back Sonar or Clearance Sonar Switch assembly)



c.
E245465E06
1.542,1.813 1.542,1.573 1.542,1.573 1.688,1.354 true 2.177,1.823 2.177,1.563 2.177,1.563 1.99,1.344 true 0.094,0.094 0.354,0.313 0.26,0.219 10 false *a 1.406,1.844 1.792,2.063 0.385,0.219 10 false ILL+ 2.104,1.854 2.49,2.073 0.385,0.219 10 false ILL-

Check that the switch illuminates.

i.

Apply battery voltage to the back sonar or clearance sonar switch assembly and check that the switch illuminates.

OK:
Tester Connection Specified Condition
Battery positive (+) → Terminal 8 (ILL+)
Battery negative (-) → Terminal 7 (ILL-)
Illuminates


Text in Illustration
*a Component without harness connected
(Back Sonar or Clearance Sonar Switch Assembly)

If the result is not as specified, replace the back sonar or clearance sonar switch assembly.