Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255512 PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)  C1622  Open or Short Circuit in Back Camera Signal  


DESCRIPTION

This DTC is stored if the parking assist ECU judges as a result of its self check that the signals or signal lines between the parking assist ECU and the rear television camera assembly are not normal.

DTC Code DTC Detection Condition Trouble Area
C1622 An open or short in the rear television camera signal circuit
·

Harness or connector

·

Rear television camera assembly

·

Parking assist ECU



WIRING DIAGRAM

E245723E07
5.021,0.24 5.354,0.396 0.333,0.156 10 false CB+ 4.656,0.24 5,0.458 0.344,0.219 10 false F76 4.698,0.052 4.875,0.208 0.177,0.156 10 false 14 4.656,0.646 5,0.875 0.344,0.229 10 false F76 4.698,0.448 4.875,0.604 0.177,0.156 10 false 15 4.656,1.042 4.979,1.271 0.323,0.229 10 false F76 4.708,0.854 4.885,1.01 0.177,0.156 10 false 38 4.667,1.448 4.958,1.615 0.292,0.167 10 false F76 4.719,1.25 4.896,1.406 0.177,0.156 10 false 37 4.656,1.865 4.938,2.063 0.281,0.198 10 false F75 4.75,1.667 4.948,1.854 0.198,0.188 10 false 4 5.021,0.635 5.354,0.792 0.333,0.156 10 false CV+ 5.021,1.042 5.354,1.198 0.333,0.156 10 false CV- 5.01,1.458 5.438,1.615 0.427,0.156 10 false CGND 1.833,0.229 2.198,0.49 0.365,0.26 10 false CB+ 1.844,0.646 2.208,0.875 0.365,0.229 10 false CV+ 1.854,1.042 2.219,1.25 0.365,0.208 10 false CV- 1.719,1.448 2.177,1.625 0.458,0.177 10 false CGND 2.229,0.156 2.375,0.375 0.146,0.219 10 false 4 2.229,0.563 2.417,0.802 0.188,0.24 10 false 2 2.219,0.969 2.375,1.177 0.156,0.208 10 false 1 2.229,1.365 2.469,1.552 0.24,0.188 10 false 3 5.021,1.854 5.448,2.01 0.427,0.156 10 false GND1 4.979,2.198 6.302,2.479 1.323,0.281 10 false Parking Assist ECU 0.781,1.708 1.146,1.938 0.365,0.229 10 false S5 0.771,1.865 2.344,2.271 1.573,0.406 10 false Rear Television Camera Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the parking assist ECU after the battery terminal disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/ Side Monitor System) may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>CALIBRATION).



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA AND BODY GROUND)
a.

Disconnect the F75 and F76 parking assist ECU connectors.


b.

Disconnect the S5 rear television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F76-38 (CV-) - S5-1 (CV-) Always Below 1 Ω
F76-15 (CV+) - S5-2 (CV+) Always Below 1 Ω
F76-14 (CB+) - S5-4 (CB+) Always Below 1 Ω
F76-37 (CGND) - S5-3 (CGND) Always Below 1 Ω
F75-4 (GND1) - Body ground Always Below 1 Ω
F76-38 (CV-) - Body ground Always 10 kΩ or higher
F76-15 (CV+) - Body ground Always 10 kΩ or higher
F76-14 (CB+) - Body ground Always 10 kΩ or higher
F76-37 (CGND) - Body ground Always 10 kΩ or higher




OK

2.CHECK PARKING ASSIST ECU (CB+, CGND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK PARKING ASSIST ECU (CB+, CGND)
a.
U166329E02
1.073,1.156 1.156,1.438 1.156,1.438 1.333,1.438 true 1.125,0.99 1.031,0.688 1.031,0.688 0.854,0.688 true 0.125,0.083 0.302,0.26 0.177,0.177 10 false *a 0.51,0.583 0.813,0.781 0.302,0.198 10 false CB+ 1.531,0.542 1.802,0.719 0.271,0.177 10 false F76 1.396,1.354 1.833,1.531 0.438,0.177 10 false CGND

Reconnect the F75 and F76 parking assist ECU connectors.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F76-37 (CGND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F76-14 (CB+) - F76-37 (CGND) Engine switch on (IG), shift lever in R 5.5 to 7.05 V



Text in Illustration
*a Component with harness connected
(Parking Assist ECU)


OK

3.CHECK REAR TELEVISION CAMERA ASSEMBLY (CV+, CGND)

NG

3.CHECK REAR TELEVISION CAMERA ASSEMBLY (CV+, CGND)
a.

Reconnect the S5 rear television camera assembly connector.

E349797E01
0.823,0.49 1.229,0.771 0.406,0.281 0.521,0.979 0.5,0.75 0.5,0.75 0.375,0.75 true 0.51,1.115 0.604,1.344 0.604,1.344 0.76,1.344 true 3.792,2.188 3.677,2.188 3.677,2.188 3.625,1.594 false 4.26,2.042 4.063,2.042 4.063,2.042 3.729,1.573 false 6.229,2.167 6.063,2.167 6.063,2.167 5.958,1.469 false 6.625,2.01 6.448,2.01 6.448,2.01 6.073,1.427 false 0.177,0.135 0.49,0.333 0.313,0.198 10 false *a 3.115,0.115 3.427,0.313 0.313,0.198 10 false *b 5.406,0.135 5.719,0.333 0.313,0.198 10 false *c 3.844,2.115 4.156,2.313 0.313,0.198 10 false *d 4.313,1.958 4.625,2.156 0.313,0.198 10 false *e 6.271,2.073 6.583,2.271 0.313,0.198 10 false *d 6.677,1.917 6.99,2.115 0.313,0.198 10 false *e 0.073,0.656 0.385,0.854 0.313,0.198 10 false CV+ 0.865,0.542 1.219,0.729 0.354,0.188 10 true F76 0.823,1.26 1.292,1.458 0.469,0.198 10 false CGND 2.844,1.073 3.313,1.271 0.469,0.198 10 false GND 5.125,1.063 5.594,1.26 0.469,0.198 10 false GND

Text in Illustration
*a Component with harness connected
(Parking Assist ECU)
*b Waveform A
*c Waveform B *d Synchronization Signal
*e Video Waveform - -


b.

Check the waveform of the rear television camera assembly using an oscilloscope.

HINT:
·

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the multi-media module receiver assembly with the connector connected.

·

The video waveform changes according to the image sent by the rear television camera assembly.



Item Content
Terminal No. (Symbol) F76-15 (CV+) - F76-37 (CGND)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition
·

Waveform A: Engine switch on (IG), shift lever in R and camera lens is not covered, displaying an image

·

Waveform B: Engine switch on (IG), shift lever in R and camera lens is covered, blacking out the screen



OK:

Waveform is as shown in the illustration.




OK

NG