This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1694 | Maximum steering angle has not been memorized | ·
Steering angle setting ·
Parking assist ECU |
When "System initializing" is displayed on the parking assist ECU after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/ Side Monitor System) may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>PRECAUTION).
Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.
Refer to steering angle setting (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>CALIBRATION).
NEXT
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>DTC CHECK / CLEAR).
DTC C1694 is not output.
If DTC C1694 is output, perform the steering angle setting again.
If DTC C1694 is still output after performing the steering angle setting 3 times, replace the parking assist ECU.
OK
NG