Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255512 PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)  C168D  Vehicle Information Unmatched  


DESCRIPTION

This DTC is stored if the parking assist ECU judges as a result of its self check that the vehicle information received via CAN communication and the vehicle information stored in the parking assist ECU do not match.

DTC Code DTC Detection Condition Trouble Area
C168D Vehicle Information Unmatched
·

Back camera position setting

·

Steering angle setting

·

Side camera position setting

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the parking assist ECU after the battery terminal disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/ Side Monitor System) may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>PRECAUTION).



PROCEDURE

1.PERFORM SETTINGS (BACK CAMERA POSITION SETTING, STEERING ANGLE SETTING, SIDE CAMERA POSITION SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.






NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>DTC CHECK / CLEAR).

OK:

DTC C168D is not output.


HINT:
·

If DTC C168D is output, perform the procedure to allow the parking assist ECU to store the vehicle information again.

·

If DTC C168D is still output after performing the procedure to make the parking assist ECU store the vehicle information 3 times, replace the parking assist ECU.





OK

END (SETTINGS ARE DEFECTIVE)

NG