These DTCs are stored if the parking assist ECU judges as a result of its self check that the signals or signal lines between the parking assist ECU and the rear television camera assembly are not normal.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1622 | An open or short in the rear television camera signal circuit | ·
Harness or connector ·
Rear television camera assembly ·
Parking assist ECU |
When "!" mark is displayed on the multi-display after the battery terminal disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Disconnect the F76 parking assist ECU connector.
Disconnect the S30 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F76-38 (CV-) - S30-2 (CV-) | Always | Below 1 Ω |
| F76-15 (CV+) - S30-3 (CV+) | Always | Below 1 Ω |
| F76-14 (CB+) - S30-6 (CB+) | Always | Below 1 Ω |
| F76-37 (CGND) - S30-5 (CGND) | Always | Below 1 Ω |
| F76-13 (SGND) - Body ground | Always | Below 1 Ω |
| F76-38 (CV-) or S30-2 (CV-) - Body ground | Always | 10 kΩ or higher |
| F76-15 (CV+) or S30-3 (CV+) - Body ground | Always | 10 kΩ or higher |
| F76-14 (CB+) or S30-6 (CB+) - Body ground | Always | 10 kΩ or higher |
| F76-37 (CGND) or S30-5 (CGND) - Body ground | Always | 10 kΩ or higher |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 38 (CV-) - Body ground | Always | 10 kΩ or higher |
| 37 (CGND) - Body ground | Always | 10 kΩ or higher |
| *a | Component without harness connected
(Parking Assist ECU) |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F76-37 (CGND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F76-14 (CB+) - F76-37 (CGND) | Engine switch on (IG) | 5.5 to 7.05 V |
| *a | Component with harness connected
(Parking Assist ECU) |
OK
NG
Check the waveform of the rear television camera assembly using an oscilloscope.
| *a | Component with harness connected
(Parking Assist ECU) |
*b | Waveform A |
| *c | Waveform B | *d | Synchronization Signal |
| *e | Video Waveform | - | - |
The video waveform changes according to the image sent by the rear television camera assembly.
| Item | Content |
|---|---|
| Terminal No. (Symbol) | F76-15 (CV+) - F76-37 (CGND) |
| Tool Setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | ·
Waveform A: Engine switch on (IG), shift lever in R and camera lens is not covered, displaying an image ·
Waveform B: Engine switch on (IG), shift lever in R and camera lens is covered, blacking out the screen |
Waveform is as shown in the illustration.
OK
NG