Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › MULTI-TERRAIN MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255515 MULTI-TERRAIN MONITOR SYSTEM C

PARK ASSIST / MONITORING  MULTI-TERRAIN MONITOR SYSTEM  U0073  Control Module Communication Bus "A" Off  U0100  Lost Communication with ECM / PCM "A"  U0114  Lost Communication with 4WD Control ECU  U0124  Lost Communication with Lateral Acceleration Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0130  Lost Communication with Steering Effort Control Module  U0140  Lost Communication with Body Control Module  U0233  Lost Communication with Blind Spot Monitor Master Module  U1110  Lost Communication with Clearance Sonar Module  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the parking assist ECU.

HINT:

If CAN communication system DTCs are stored, they may also be stored in other systems.


DTC Code DTC Detection Condition Trouble Area
U0073 Control module communication bus off CAN communication system
U0100 Lost communication with ECM
U0114 Lost communication with 4WD Control ECU
U0126 Lost communication with steering angle sensor
U0129 Lost communication with brake actuator assembly (skid control ECU)
U0130 Lost communication with VGRS
U0140 Lost communication with main body ECU
U0233 Lost communication with blind spot monitor sensor LH
U1110 Lost communication with clearance warning ECU assembly

PROCEDURE

1.CHECK FOR DTC

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR).

OK:

U0073, U0100, U0114, U0126, U0129, U0130, U0140, U0233 or U1110 is not output.


Result
Result Proceed to
OK A
NG (for LHD with Central Gateway ECU) B
NG (for RHD with Central Gateway ECU) C


HINT:
·

If CAN communication system DTCs are stored, they may also be stored in other systems.

·

If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR).




A

B

C