Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255516 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1ABC  Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete  


DESCRIPTION

This DTC is stored when a beam axis adjustment has not been performed for the blind spot monitor sensor RH.

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis adjustment is performed. Completing the beam axis adjustment after replacing a blind spot monitor sensor prevents this DTC from being output.


DTC No. DTC Detection Condition Trouble Area
C1ABC A beam axis adjustment has not been performed Blind spot monitor sensor RH

PROCEDURE

1.PERFORM BLIND SPOT MONITOR BEAM AXIS ADJUSTMENT
a.

Perform the Blind Spot Monitor Beam Axis Adjustment using the GTS.

HINT:

Refer to Blind Spot Monitor Beam Axis Confirmation (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK).




NEXT

END