84480F
1.INSPECT MAIN SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 (IG) - 7 (ECU) | Main switch assembly on | Below 1 Ω |
| 1 (IG) - 7 (ECU) | Main switch assembly off | 10 kΩ or higher |
| *a | Component without harness connected
(Multi-terrain Monitor Switch) |
Check that the switch illuminates.
Apply battery voltage to the back sonar or clearance sonar switch assembly and check that the switch illuminates.
| Tester Connection | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 5 (ILL-) |
Illuminates |