27310B
1.INSTALL GENERATOR DRIVE END FRAME BEARING
Using SST and a press, press in a new drive end frame bearing.
Fit the tabs on the retainer plate into the cutouts on the generator drive end frame to install the retainer plate.
| *1 | Tab |
| *2 | Cutout |
Install the 4 screws.
27330
2.INSTALL GENERATOR ROTOR ASSEMBLY
Install the generator rotor to the generator drive end frame.
Place a new generator washer on the generator rotor.
27360
3.INSTALL GENERATOR COIL ASSEMBLY
Using a deep socket wrench (21 mm) and press, slowly press in the generator coil.
| *1 | Deep Socket Wrench (21 mm) |
Install the 4 bolts.
27370
4.INSTALL GENERATOR BRUSH HOLDER ASSEMBLY
While pushing the 2 brushes into the brush holder, insert a pin with a diameter of 1.0 mm (0.0394 in.) into the brush holder hole.
| *1 | Pin |
Install the brush holder to the generator coil with the 2 screws.
| *1 | Pin |
Pull out the pin from the brush holder.
27387
5.INSTALL TERMINAL INSULATOR
Install the terminal insulator to the generator coil.
Make sure the terminal insulator is installed facing the proper direction.
27039
6.INSTALL GENERATOR REAR END COVER
Install the generator rear end cover to the generator coil with the 3 nuts.
Install the cord clip with the nut.
27415
7.INSTALL GENERATOR PULLEY WITH CLUTCH
Temporarily install the generator pulley with clutch by hand.
Mount the generator in a vise between aluminum plates.
Install SST (A) and SST (B) to the generator pulley with clutch as shown in the illustration.
| *1 | Rotor Shaft |
Securely attach SST to the generator pulley with clutch and rotor shaft.
Using a wrench to hold SST (A), turn SST (B) clockwise to tighten the generator pulley with clutch.
| *1 | Fulcrum Length |
| *a | Hold |
|
Turn |
Be careful as the generator pulley with clutch or rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.
Use a torque wrench with a fulcrum length of 400 mm (15.7 in.). When using a torque wrench with a fulcrum length that is not 400 mm (15.7 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Make sure SST and the wrench are connected in a straight line.
Remove SST from the generator.
Check that the generator pulley with clutch rotates smoothly.
27416
8.INSTALL GENERATOR PULLEY CAP
Install a new generator pulley cap to the generator pulley with clutch.