Home › Power Source / Network › 3UR-FE (BATTERY / CHARGING) › GENERATOR
RM2660E _57 Power Source / Network _052834 3UR-FE BATTERY / CHARGING _0255525 GENERATOR G

3UR-FE BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27330 1.INSPECT GENERATOR ROTOR ASSEMBLY

a.

Check the resistance.

i.
A117220E02
1.231,1.091 0.967,0.724 0.967,0.724 0.719,0.724 false 0.516,0.641 0.688,0.797 0.172,0.156 10 *1 1.129,1.138 0.831,0.724 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.5 to 1.9 Ω


Text in Illustration
*1 Slip Ring

If the result is not as specified, replace the generator rotor assembly.


ii.
A117221E01
0.514,0.81 0.681,0.969 0.166,0.159 10 *1 2.32,0.284 2.487,0.443 0.166,0.159 10 *2 1.017,1.174 0.808,0.897 0.808,0.897 0.705,0.897 false 1.96,0.848 2.207,0.371 2.207,0.371 2.318,0.371 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Rotor core Always 10 kΩ or higher


Text in Illustration
*1 Slip Ring
*2 Rotor Core

If the result is not as specified, replace the generator rotor assembly.



b.
A117222E03
0.619,0.521 0.800,0.686 0.181,0.165 10 *1

Using a vernier caliper, measure the slip ring diameter.

Standard diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)


Minimum diameter:

14.0 mm (0.551 in.)


Text in Illustration
*1 Diameter

If the diameter is less than the minimum, replace the generator rotor assembly.


c.
A163064

Check that the generator rotor bearing is not rough or worn.

If necessary, replace the generator rotor assembly.


Hide 27370 2.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A128079E06
0.693,0.687 0.870,0.857 0.177,0.170 10 *1

Using a vernier caliper, measure the brush length.

Standard exposed length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum exposed length:

4.5 mm (0.177 in.)


Text in Illustration
*1 Length

If the brush length is less than the minimum, replace the generator brush holder assembly.