| DTC Code | DTC Detection Condition | Specified Condition |
|---|---|---|
| U1110 | There is no communication from the clearance warning ECU assembly. | ·
Power source circuit of clearance warning ECU assembly ·
Clearance warning ECU assembly CAN branch wire or connector ·
Clearance warning ECU assembly |
For vehicles with the TOYOTA parking assist-sensor system and without the side monitor system.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
NEXT
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
For vehicles with an SRS system:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
NEXT
Disconnect the F12 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F12-3 (CANH) - F12-5 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector
(to Clearance Warning ECU Assembly) |
OK
NG
Connect the cable to the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F12-15 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F12-17 (GND1) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Clearance Warning ECU Assembly) |
OK
NG