Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052838 DOOR LOCK _0255542 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 69780B 1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

Hide 69740D 2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

Hide 69340 3.INSTALL REAR DOOR LOCK ASSEMBLY LH

a.
B183927

Apply MP grease to the sliding parts of the rear door lock assembly.


b.

Insert the rear door lock assembly to the rear door outside handle release plate, and set it to the rear door panel.


c.

Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.


d.

Using a T30 ''TORX'' wrench, the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 67842E 4.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 81230 5.INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 67604 6.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74611C 7.INSTALL ASSIST GRIP COVER LH

Hide 69278C 8.INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

Hide 74280 9.INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).