In some cases, wireless door lock control functions are normal but the turn signal lights and wireless door lock buzzer are not. Malfunctions may be present in the main body ECU, certification ECU (smart key ECU assembly), turn signal lights, and/or wireless door lock buzzer signal outputs.*
Before performing the inspection, check that there are no problems related to the CAN communication system and LIN communication system.
When troubleshooting a function, first make sure that the answer-back function is set to the default setting.
Check that DTC B1242 is not output.
When troubleshooting a function, first make sure that the open door warning function is set to the default setting.
*: For Europe and China, there is no buzzer sound answer-back function.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| D Lock Pos switch | Driver side door lock position switch signal / ON or OFF | ON: Driver side door lock is unlocked
OFF: Driver side door lock is locked |
- |
| P Lock Pos switch | Passenger side door lock position switch signal / ON or OFF | ON: Passenger side door is unlocked
OFF: Passenger side door is locked |
- |
| RL Lock Pos switch | Rear door LH lock position switch signal / ON or OFF | ON: Rear side door LH is unlocked
OFF: Rear side door LH is locked |
- |
| RR Lock Pos switch | Rear door RH lock position switch signal / ON or OFF | ON: Rear side door RH is unlocked
OFF: Rear side door RH is locked |
- |
| Back Lock Pos switch | Back door lock position switch signal / ON or OFF | ON: Back door is unlocked
OFF: Back door is locked |
- |
On the intelligent tester screen, the display changes between LOCK and UNLOCK as shown in the chart above.
Go to POWER DOOR LOCK CONTROL SYSTEM (Proceed to Only Driver Door LOCK/UNLOCK Functions do not Operate) (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).
Go to POWER DOOR LOCK CONTROL SYSTEM (Proceed to Only Passenger Door LOCK/UNLOCK Functions do not Operate) (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).
Go to POWER DOOR LOCK CONTROL SYSTEM (Proceed to Only Rear Door LH LOCK/UNLOCK Functions do not Operate) (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).
Go to POWER DOOR LOCK CONTROL SYSTEM (Proceed to Only Rear Door RH LOCK/UNLOCK Functions do not Operate) (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).
Go to POWER DOOR LOCK CONTROL SYSTEM (Proceed to Only Back Door LOCK/UNLOCK Functions do not Operate) (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).
OK
NG
Check that the wireless door lock control functions operate with a transmitter (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System)>OPERATION CHECK).
| Result | Proceed to |
|---|---|
| Wireless door lock control functions operate normally but turn signal light answer-back does not occur | A |
| Wireless door lock control functions operate normally but wireless door lock buzzer answer-back does not occur | B |
A
B
Check that the turn signal lights flash continuously when the hazard warning signal switch is pressed (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>OPERATION CHECK).
Hazard warning lights flash continuously.
OK
NG
Disconnect the E29 ECU connector.
Disconnect the A20 buzzer connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A20-1 - E29-21 (BZR) | Always | Below 1 Ω |
| A20-2 - Body ground | ||
| A20-1 - Body ground | Always | 10 kΩ or higher |
OK
NG
Temporarily replace the wireless door lock buzzer with a new one (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK BUZZER>REMOVAL).
Check that the wireless door lock buzzer sounds by using the transmitter lock/unlock switch.
Wireless door lock buzzer sounds.
OK
NG