Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL SWITCH
RM2660E _58 Vehicle Interior _052838 DOOR LOCK _0255558 DOOR CONTROL SWITCH G

DOOR LOCK  DOOR CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84930 1.INSPECT DOOR CONTROL SWITCH ASSEMBLY

a.
B180461E06
1.781,0.667 2.5,0.667 false 1.49,0.667 0.979,0.667 false 1.76,3.604 2.052,4.052 false 1.635,3.604 1.635,4.042 false 1.469,3.615 1.26,4.042 false 2.573,0.573 2.771,0.771 0.198,0.198 10 false *c 0.74,0.573 0.948,0.75 0.208,0.177 10 false *b 0.281,2.167 0.469,2.385 0.188,0.219 10 false *a 1.188,4.052 1.365,4.281 0.177,0.229 10 false L 1.958,4.052 2.156,4.229 0.198,0.177 10 false UL 1.573,4.052 1.729,4.229 0.156,0.177 10 false E

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (UL) - 3 (E) Unlock Below 1 Ω
2 (UL) - 3 (E) Off 10 kΩ or higher
4 (L) - 3 (E)
4 (L) - 3 (E) Lock Below 1 Ω


If the result is not as specified, replace the door control switch assembly.


Text in Illustration
*a Unlock
*b Lock
*c Component without harness connected
(Door Control Switch Assembly)


b.
B180462E03
1.906,3.677 1.969,4.104 false 1.615,3.667 1.542,4.104 false 0.26,2.229 2.74,2.677 2.479,0.448 10 false *a 1.938,4.104 2.167,4.302 0.229,0.198 10 false IG 1.469,4.115 1.615,4.292 0.146,0.177 10 false E

Apply battery voltage to the switch connector and check that the indicator (LED) illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1 (IG)
Battery negative (-) → Terminal 3 (E)
Indicator (LED) illuminates


If the result is not as specified, replace the door control switch assembly.

Text in Illustration
*a Component without harness connected
(Door Control Switch Assembly)