Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY LOCK AND UNLOCK SWITCH (for Rear) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255565 ENTRY LOCK AND UNLOCK SWITCH(for Rear) G

THEFT DETERRENT / KEYLESS ENTRY  ENTRY LOCK AND UNLOCK SWITCH(for Rear)  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 69240 1.INSPECT ENTRY LOCK AND UNLOCK SWITCH

B184271E01
2.406,2.188 2.866,2.356 0.460,0.169 10 TRG- 2.406,2.724 2.866,2.893 0.460,0.169 10 TRG+ 1.775,2.648 2.36,2.246 false 1.786,2.811 2.343,2.811 false 0.211,1.236 2.712,1.623 2.501,0.386 10 Component without harness connected: (Entry Lock and Unlock Switch)

a.

Disconnect the connector.


b.

Remove the outside handle.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (TRG-) - 3 (TRG+) Lock switch not pushed (OFF) 10 kΩ or higher
1 (TRG-) - 3 (TRG+) Lock switch pushed (ON) Below 1 Ω


If the result is not as specified, replace the entry lock and unlock switch.