Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE HOOD COURTESY SWITCH › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255569 ENGINE HOOD COURTESY SWITCH G

THEFT DETERRENT / KEYLESS ENTRY  ENGINE HOOD COURTESY SWITCH  INSPECTION  


PROCEDURE

Hide 84231E 1.INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)

a.

for Engine Hood Courtesy Switch Connector 2 Pin Type (for LHD Vehicle):

B219990E02
4.595,0.469 7.126,0.799 2.531,0.330 10 Component without harness connected: (Hood Lock Assembly) 0.633,2.258 1.806,2.407 1.172,0.149 10 Unlock Position 3.276,2.258 4.449,2.407 1.172,0.149 10 Lock Position 0.045,0.045 5.686,0.210 5.640,0.165 12 for Engine Hood Courtesy Switch Connector 2 Pin Type (for LHD Vehicle):

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Unlock 10 kΩ or higher
1 - 2 Lock Below 1 Ω


If the result is not as specified, replace the hood lock assembly.



b.

for Engine Hood Courtesy Switch Connector 2 Pin Type (for RHD Vehicle):

B219989E02
4.614,0.43 7.146,0.760 2.531,0.330 10 Component without harness connected: (Hood Lock Assembly) 1.01,2.205 2.183,2.355 1.172,0.149 10 Unlock Position 3.614,2.205 4.786,2.355 1.173,0.149 10 Lock Position 0.057,0.032 5.641,0.197 5.584,0.165 12 for Engine Hood Courtesy Switch Connector 2 Pin Type (for RHD Vehicle):

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Unlock 10 kΩ or higher
1 - 2 Lock Below 1 Ω


If the result is not as specified, replace the hood lock assembly.



c.

for Engine Hood Courtesy Switch Connector 4 Pin Type:

B216369E03
4.602,0.221 7.133,0.551 2.531,0.330 10 Component without harness connected: (Hood Lock Assembly) 1.005,2.33 2.000,2.479 0.994,0.149 10 Unlock Position 0.046,0.06 4.355,0.225 4.308,0.165 12 for Engine Hood Courtesy Switch Connector 4 Pin Type: 3.602,2.33 4.537,2.479 0.935,0.149 10 Lock Position

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 3 Always Below 1 Ω
2 - 4 Unlock 10 kΩ or higher
2 - 4 Lock Below 1 Ω


If the result is not as specified, replace the hood lock assembly.