Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (w/ Entry and Start System) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255571 THEFT DETERRENT SYSTEM(w/ Entry and Start System) J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM(w/ Entry and Start System)  Certification ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the certification ECU (smart key ECU assembly).

WIRING DIAGRAM

B176071E02
5.559,0.789 5.813,0.958 0.254,0.169 10 +B 5.334,0.702 5.610,0.871 0.276,0.169 10 1 5.286,2.008 5.562,2.177 0.276,0.169 10 17 5.459,2.897 5.804,3.050 0.345,0.153 10 E29 5.459,3.039 7.030,3.378 1.571,0.339 10 Certification ECU (Smart Key ECU Assembly) 3.254,0.951 3.592,1.120 0.338,0.169 10 IMB 0.912,0.813 1.726,0.982 0.814,0.169 10 from Battery 5.55,2.098 5.984,2.266 0.433,0.169 10 E

PROCEDURE

1.INSPECT FUSE (IMB)
a.

Remove the IMB fuse from the engine room relay block.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
IMB fuse Always Below 1 Ω




OK

2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - BATTERY AND BODY GROUND)

NG

REPLACE FUSE

2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - BATTERY AND BODY GROUND)
U164111E02
0.198,2.656 0.302,2.198 true 3.219,2.635 3.115,2.167 true 0.125,2.688 0.323,2.885 0.198,0.198 10 false +B 3.167,2.656 3.292,2.854 0.125,0.198 10 false E 0.094,0.083 2.99,0.594 2.896,0.51 10 false Front view of wire harness connector: (to Certification ECU [Smart Key ECU Assembly]) 0.281,1.448 0.604,1.646 0.323,0.198 10 false E29

a.

Disconnect the E29 ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E29-17 (E) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
E29-1 (+B) - Body ground Always 11 to 14 V




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR