Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255573 ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System) J

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System)  ID Code Box Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the ID code box.

WIRING DIAGRAM

B182870E08
1.427,2.948 2.281,3.167 0.854,0.219 10 false from Battery 4.042,1.323 4.354,1.479 0.313,0.156 10 false IMB 5.51,1.104 5.823,1.26 0.313,0.156 10 false +B 5.24,0.958 5.365,1.115 0.125,0.156 10 false 1 5.24,1.854 5.365,2.01 0.125,0.156 10 false 8 5.542,1.979 5.896,2.135 0.354,0.156 10 false GND 5.198,2.854 5.521,3.021 0.323,0.167 10 false E28 5.198,3.021 6.729,3.635 1.531,0.615 10 false ID Code Box (Immobiliser Code ECU)

PROCEDURE

1.INSPECT FUSE (IMB)
a.

Remove the IMB fuse from the engine room relay block.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
IMB fuse Always Below 1 Ω




OK

2.CHECK HARNESS AND CONNECTOR (ID CODE BOX (IMMOBILISER CODE ECU) - BATTERY AND BODY GROUND)

NG

REPLACE FUSE

2.CHECK HARNESS AND CONNECTOR (ID CODE BOX (IMMOBILISER CODE ECU) - BATTERY AND BODY GROUND)
U163844E02
0.958,2.563 1.115,2.281 true 2.51,2.563 2.333,2.281 true 0.854,2.583 1.083,2.781 0.229,0.198 10 false +B 2.375,2.604 2.76,2.802 0.385,0.198 10 false GND 0.135,0.052 2.698,0.427 2.563,0.375 10 false Front view of wire harness connector: (to ID Code Box (Immobiliser Code ECU)) 0.333,2.021 0.646,2.219 0.313,0.198 10 false E28

a.

Disconnect the E28 ID code box connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E28-8 (GND) - Body ground Always Below 1 Ω


Standard Voltage:
Tester Connection Condition Specified Condition
E28-1 (+B) - Body ground Always 11 to 14 V




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR