Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255574 ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System)  B2793  Transponder Chip Malfunction  B2794  Unmatched Encryption Code  B2797  Communication Malfunction No. 1  B2798  Communication Malfunction No. 2  


DESCRIPTION

DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.

DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.

DTC B2797 is stored when a key with a Bcc malfunction is inserted into the ignition key cylinder.

DTC B2798 is stored when a key is inserted into the ignition key cylinder but a communication error occurs between the key and transponder key ECU assembly.


DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation
B2793 A transponder chip malfunction (1 trip detection logic*).
·

Key

·

Harness or connector

·

Transponder key amplifier

·

Transponder key ECU assembly


Insert the key into the ignition key cylinder.
B2794 A key with an incomplete key code is inserted into the ignition key cylinder (1 trip detection logic*).
B2797 A key with a Bcc malfunction is inserted into the ignition key cylinder (1 trip detection logic*).
B2798 Key code identification cannot be completed within the specified time (1 trip detection logic*).

*: Only output while a malfunction is present.


Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation When Malfunction Detected
Engine cannot be started -

Related Data List and Active Test
DTC Code Data List and Active Test
B2793 Abnormal Status
B2794 Different Encrypt Code
B2797 Bcc Malfunction
B2798 Frame Error

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the key and transponder key ECU assembly, refer to the Service Bulletin.

·

After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.



PROCEDURE

2.CHECK FOR DTC
a.

Insert and remove each registered key one at a time, and check for DTCs each time (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System)>DTC CHECK / CLEAR).

HINT:
·

Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

·

If a DTC is output, clear the DTCs before checking the next key.



OK:

DTCs B2793, B2974, B2797 and B2798 are not output.


Result
Result Proceed to
OK A
NG (all keys) B
NG (any key) C



A

B

3.CHECK CONNECTION OF CONNECTOR

C

REPLACE KEY THAT CANNOT START ENGINE

3.CHECK CONNECTION OF CONNECTOR
a.

Check that the connectors are properly connected to the transponder key amplifier.


b.

Check that the engine starts with the key.

OK:

Engine starts.




OK

END (CONNECTOR WAS NOT CONNECTED PROPERLY)

NG

4.REPLACE TRANSPONDER KEY AMPLIFIER
4.REPLACE TRANSPONDER KEY AMPLIFIER

b.

c.

Check that the engine starts with the key.

OK:

Engine starts.




OK

END (TRANSPONDER KEY AMPLIFIER WAS DEFECTIVE)

NG

REPLACE TRANSPONDER KEY ECU ASSEMBLY