This code is stored when an ECM that is incompatible with the engine immobiliser system is installed to the vehicle.
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
|---|---|---|---|
| B279C | An ECM that is incompatible with the engine immobiliser system is installed (1 trip detection logic*). | ECM | Check for DTCs. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC Code | Data List and Active Test |
|---|---|
| B279C | - |
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Replace the current ECM with the proper ECM.
for 1GR-FE (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>ECM>REMOVAL)
for 1VD-FTV (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECM>REMOVAL)
NEXT