Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT(for Front) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052840 LIGHTING (INT) _0255579 ROOM LIGHT(for Front) G

LIGHTING (INT)  ROOM LIGHT(for Front)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 81260A 1.CHECK MAP LIGHT ASSEMBLY

a.
U165855E02
2.583,1.323 2.885,1.146 false 1.958,1.438 1.969,2.188 false 1.51,1.438 1.563,2.198 false 1.156,1.438 1.135,2.208 false 0.313,2.094 0.792,1.333 false 0.813,2.198 0.927,1.427 false 2.573,1.635 2.615,2.104 false 2.885,1.073 3.292,1.25 0.406,0.177 10 false GND6 1.854,2.208 2.167,2.385 0.313,0.177 10 false RILL 1.469,2.24 1.729,2.417 0.26,0.177 10 false ILL- 1.042,2.24 1.333,2.417 0.292,0.177 10 false ILL+ 0.083,2.104 0.521,2.281 0.438,0.177 10 false DOME 0.719,2.208 0.906,2.385 0.188,0.177 10 false +B 2.406,2.104 2.813,2.281 0.406,0.177 10 false GND9 0.469,0.031 2.802,0.427 2.333,0.396 10 false Component with harness connected: (Map Light) 0.302,1.354 0.5,1.531 0.198,0.177 10 false R7

Remove the map light with the connector connected.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
R7-6 (RILL) - R7-17 (GND9) Rear dome light off 11 to 14 V
Rear dome light on Below 1 V
R7-10 (ILL-) - R7-17 (GND9) Headlight dimmer switch off 11 to 14 V
Headlight dimmer switch on Below 1 V
R7-13 (ILL+) - R7-17 (GND9) Engine switch on (ACC) 11 to 14 V
R7-15 (+B) - R7-17 (GND9) Always 11 to 14 V
R7-16 (DOME) - R7-17 (GND9) Always 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R7-1 (GND6) - Body ground Always Below 1 Ω
R7-17 (GND9) - Body ground Always Below 1 Ω


If the result is not as specified, replace the map light assembly.