81260A
1.INSPECT MAP LIGHT ASSEMBLY
Remove the map light assembly with the connector connected.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (RILL) - 17 (GND9) | Battery save system (interior light auto cut function) operating → Battery save system (interior light auto cut function) not operating | 11 to 14 V |
| 32 (ILLB) - 17 (GND9) | 11 to 14 V | |
| 13 (GILL) - 17 (GND9) | Light control switch tail | 11 to 14 V |
| 6 (RILL) - 17 (GND9) | No. 1 room light on → off | 11 to 14 V |
If the result is not as specified, replace the map light assembly.
| *a | Component with harness connected
(Map Light Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 17 (GND9) - Body ground | Always | Below 1 Ω |
| 3 (GND5) - Body ground | Always | Below 1 Ω |
If the result is not as specified, replace the map light assembly.
| *a | Component with harness connected
(Map Light Assembly) |