Home › Vehicle Interior › LIGHTING (INT) › RELAY › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052840 LIGHTING (INT) _0255589 RELAY G

LIGHTING (INT)  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 28300 1.INSPECT LIGHT CUT RELAY

E271960

a.

Remove the light cut relay from the engine room relay box.


b.
E256070E01
2.376,1.305 2.509,1.461 0.133,0.156 10 2 2.812,1.306 2.945,1.461 0.133,0.156 10 1 2.812,0.674 2.945,0.830 0.133,0.156 10 3 2.376,0.674 2.509,0.830 0.133,0.156 10 5 2.92,1.391 3.015,1.391 false 2.277,1.391 2.365,1.391 false 2.708,0.631 2.803,0.727 false 2.486,0.754 2.622,0.891 false 1.556,1.352 1.689,1.508 0.133,0.156 10 2 0.279,1.356 0.411,1.512 0.133,0.156 10 1 0.279,0.642 0.411,0.798 0.133,0.156 10 3 1.556,0.851 1.689,1.007 0.133,0.156 10 5

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the light cut relay.


c.

Install the light cut relay to the engine room relay box.