Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
81080S
1.INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY LH
Apply battery voltage to the connector and check the light illumination condition.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 2 (B)
Battery negative(-) → 1 (L) |
Illuminates |
If the result is not as specified, replace the No. 1 interior illumination light assembly LH.
| *a | Component without harness connected
(No. 1 Interior Illumination Light Assembly LH) |