Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81080J
1.INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY
Apply battery voltage to the connector and check the light illumination condition.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 2 (B)
Battery negative(-) → 1 (L) |
Illuminates |
If the result is not as specified, replace the No. 1 interior illumination light assembly.
| *a | Component without harness connected
(No. 1 Interior Illumination Light Assembly) |