Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255601 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1610/13  Front Airbag Sensor RH Malfunction  


DESCRIPTION

The front airbag sensor RH consists of the diagnostic circuit and the frontal deceleration sensor, etc.

If the center airbag sensor receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.

DTC B1610/13 is stored when a malfunction is detected in the front airbag sensor RH circuit.

DTC Code DTC Detection Condition Trouble Area
B1610/13 When one of the following conditions is met:
·

A front airbag sensor RH malfunction.

·

A center airbag sensor malfunction.


·

Front airbag sensor RH

·

Center airbag sensor assembly



WIRING DIAGRAM

C175142E36
0.406,3.792 0.813,3.958 0.406,0.167 10 false A6 0.396,3.938 1.969,4.135 1.573,0.198 10 false Front Airbag Sensor RH 5.552,3.802 5.896,3.99 0.344,0.188 10 false E47 5.542,3.948 6.938,4.156 1.396,0.208 10 false Center Airbag Sensor 3.333,1.021 3.667,1.188 0.333,0.167 10 false AE2 3.333,2.198 3.667,2.365 0.333,0.167 10 false AE2 3.438,0.792 3.583,0.948 0.146,0.156 10 false 1 3.427,1.979 3.615,2.167 0.188,0.188 10 false 2 1.292,1.042 1.604,1.24 0.313,0.198 10 false +SR 1.292,2.208 1.604,2.406 0.313,0.198 10 false -SR 5.635,2.198 5.948,2.396 0.313,0.198 10 false -SR 5.625,1.031 5.938,1.229 0.313,0.198 10 false +SR 1.729,0.885 1.885,1.115 0.156,0.229 10 false 2 1.719,2.042 1.865,2.271 0.146,0.229 10 false 1 5.323,0.917 5.552,1.115 0.229,0.198 10 false 29 5.333,2.094 5.615,2.323 0.281,0.229 10 false 27

CAUTION / NOTICE / HINT

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

·

After replacing the center airbag sensor assembly, refer to initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



PROCEDURE

1.CHECK FRONT AIRBAG SENSOR RH
a.
C246887E01
0.423,3.392 1.218,3.733 0.795,0.341 10 Front Airbag Sensor LH 1.891,3.728 2.797,4.059 0.906,0.332 10 Center Airbag Sensor 0.423,1.363 1.218,1.704 0.795,0.341 10 Front Airbag Sensor LH 1.891,1.455 2.797,1.786 0.906,0.332 10 Center Airbag Sensor 0.075,2.173 1.332,2.398 1.258,0.225 12 w/o Side Airbag: 0.075,0.08 1.230,0.305 1.156,0.225 12 w/ Side Airbag:

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


c.

Interchange the front airbag sensor RH with LH and connect the connectors to them.


d.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.


f.

g.

Turn the ignition switch off.


h.

Turn the ignition switch to ON, and wait for at least 60 seconds.


i.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC B1610 is output A
DTC B1615 is output B
DTC B1610 and B1615 are not output C

HINT:

Codes other than DTC B1610 and B1615 may be output at this time, but they are not related to this check.




C

A

B