Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255604 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45187 2.REMOVE LOWER NO. 3 STEERING WHEEL COVER

a.
B181563

Detach the 2 claws and remove the steering wheel cover.


Hide 45186 3.REMOVE LOWER NO. 2 STEERING WHEEL COVER

a.

Detach the 2 claws and remove the steering wheel cover.

B449525E01
0.375,0.115 2.396,0.417 2.021,0.302 12 false w/o Cruise Control Switch: 3.979,0.135 6,0.438 2.021,0.302 12 false w/ Cruise Control Switch:


Hide 4.REMOVE STEERING PAD

a.

Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

B449526E01
5.469,3.219 5.802,2.979 false 0.365,0.177 2.344,0.448 1.979,0.271 12 false w/o Steering Pad Switch: 3.958,0.208 5.938,0.479 1.979,0.271 12 false w/ Steering Pad Switch: 4.927,3.229 5.792,3.438 0.865,0.208 10 false Screw Case


b.
B181568

Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.

NOTICE:

When removing the steering pad, do not pull the airbag wire harness.



c.

Disconnect the horn connector.


d.

Disconnect the 2 connectors and remove the steering pad.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.