Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR AIRBAG SENSOR › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255614 REAR AIRBAG SENSOR G

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89834 1.CHECK REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)

Hide 89834 2.CHECK REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)


b.

When the quarter panel of the vehicle or its area is damaged, check if there is any damage to the rear airbag sensor. If there are any defects as mentioned below, replace the rear airbag sensor with a new one:

·

Cracks, dents or chips on the sensor housing.

·

Cracks or other damage to the connector.

·

Peeling off of the label or damage to the serial number.


CAUTION:

For removal and installation procedures of the rear airbag sensor, be sure to follow the correct procedure.



Hide 89834 3.CHECK REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)

a.

When airbags have deployed as the result of a collision, be certain to replace all rear airbag sensors in the damaged area (anywhere in need of repair). Furthermore, it is also necessary to replace any rear airbag sensor in undamaged areas that have registered a major collision, or which exhibit any of the following abnormalities:

·

Cracks, dents or chips on the sensor housing.

·

Cracks or other damage to the connector.

·

Peeling off of the label or damage to the serial number.


CAUTION:

For removal and installation procedures of the rear airbag sensor, be sure to follow the correct procedure.