Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG CUTOFF SWITCH › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255617 CURTAIN SHIELD AIRBAG CUTOFF SWITCH G

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG CUTOFF SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT CURTAIN SHIELD AIRBAG CUTOFF SWITCH

a.

Inspect the curtain shield airbag cutoff switch.

i.
U156832E01
1.594,0.406 1.958,0.594 0.365,0.188 10 false G13 0.094,0 0.302,0.198 0.208,0.198 10 false *a

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Curtain Shield Airbag Cutoff Switch)

Standard Resistance:
Tester Connection Switch Condition Specified Condition
G13-4 - G13-1 Curtain shield airbag cutoff switch off 10 kΩ or higher
Curtain shield airbag cutoff switch on Below 1 Ω


If the result is not as specified, replace the curtain shield airbag cutoff switch.



b.

Check the illumination.

i.
U156833E01
1.698,1.25 1.531,1.729 false 1.896,1.24 1.948,1.563 false 1.604,0.427 1.969,0.615 0.365,0.188 10 false G13 0.094,0 0.302,0.198 0.208,0.198 10 false *a 1.344,1.76 1.698,1.958 0.354,0.198 10 false ILL+ 1.854,1.594 2.208,1.792 0.354,0.198 10 false ILL-

Apply battery voltage to the connector and check the LED illumination conditions.

OK:
Measurement Condition Specified Condition
Battery positive (+) → G13-3 (ILL+)
Battery negative (-) → G13-2 (ILL-)
Illuminates


Text in Illustration
*1 Component without harness connected
(Curtain Shield Airbag Cutoff Switch)

If the result is not as specified, replace the curtain shield airbag cutoff switch.