Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
72329
1.REMOVE SEAT ADJUSTER BOLT COVER
Using a screwdriver, detach the 2 claws and remove the cover.
Tape the screwdriver tip before use.
72525A
2.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
Remove the screw and release handle.
71833H
3.REMOVE REAR NO. 1 SEAT RECLINING COVER RH
Remove the 2 screws.
Detach the 3 claws in the order shown in the illustration, and then remove the cover.
71834G
4.REMOVE REAR NO. 1 SEAT RECLINING COVER LH
Remove the 2 screws.
Detach the 4 claws and remove the cover.
72266
5.REMOVE UPPER SEAT TRACK RAIL COVER LH
Using a screwdriver, detach the 2 claws and remove the cover.
Tape the screwdriver tip before use.
72265
6.REMOVE UPPER SEAT TRACK RAIL COVER RH
Using a screwdriver, detach the 2 claws and remove the cover.
Tape the screwdriver tip before use.
79951
7.REMOVE NO. 1 SEAT CUSHION COVER
Detach the 4 claws and remove the 2 covers.
79965
8.REMOVE REAR NO. 2 SEAT LEG SIDE COVER
Remove the 4 screws and detach the 3 claws.
Remove the bolt that is securing the fold seat stopper band and remove the seat leg side cover together with the fold seat stopper band.
78950C
9.REMOVE FOLD SEAT STOPPER BAND ASSEMBLY
Remove the fold seat stopper band from the seat leg side cover.
71777
10.REMOVE REAR SEAT SIDE HINGE FEMALE COVER
Using a screwdriver, detach the 6 claws and remove the 2 covers.
Tape the screwdriver tip before use.
71779
11.REMOVE REAR SEAT SIDE HINGE MALE COVER LH
Detach the clip and remove the cover.
71778
12.REMOVE REAR SEAT SIDE HINGE MALE COVER RH
Detach the clip and remove the cover.
71469
13.REMOVE REAR NO. 2 SEAT PROTECTOR
w/ Rear Seat Side Airbag:
Detach the claw and remove the wire harness connector.
w/ Seat Heater System:
Detach the claw and remove the wire harness connector.
Using a clip remover, remove the clip.
Detach the claw and remove the seat protector from the seat hinge.
Detach the 2 claws, open the protector and remove the wire harness.
71302B
14.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
Remove the 2 nuts and hinge.
71301B
15.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH
w/ Rear Seat Side Airbag:
Detach the wire harness clamp.
w/ Seat Heater System:
Detach the wire harness clamp.
Remove the 2 nuts and hinge.
Detach the cable clamp and disconnect the cable.
72995A
16.REMOVE REAR SEAT COVER
Detach the 12 claws.
Remove the 3 screws.
Detach the 2 claws and remove the cover.
76974E
17.REMOVE REAR UNDER SIDE COVER LH
Remove the 5 screws.
Detach the clip and 2 claws, and remove the cover.
79123
18.REMOVE NO. 1 SEAT CUSHION PLATE
Detach the 3 claws and remove the seat cushion plate.
78955
19.REMOVE REAR SEAT UNDER TRAY COVER RH
Remove the 2 screws.
Detach the 4 claws and remove the cover.
72203
20.REMOVE REAR SEAT TRACK HANDLE SUB-ASSEMBLY
Remove the 2 screws and seat track handle.
Detach the 2 cable clamps and disconnect the 2 cables.
Detach the cable clamp and disconnect the cable.
78091A
21.REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY
22.REMOVE SEAT CUSHION COVER WITH PAD
w/ Rear Seat Side Airbag:
Detach the side airbag wire harness clamps.
Remove the side airbag wire harness through the hole in the seat cushion.
w/ Seat Heater System:
Disconnect the 2 seat heater connectors.
Remove the seatback heater wire harness through the hole in the seat cushion.
Remove the seat cushion cover with pad.
71075S
23.REMOVE REAR SEPARATE TYPE SEAT CUSHION COVER
Detach the 3 pieces of fastening tape.
Remove the hog rings and cover.
87510P
24.REMOVE REAR SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)
Cut off the tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.
72996A
25.REMOVE REAR SEATBACK COVER
Using a screwdriver, detach the 4 claws and remove the cover.
Tape the screwdriver tip before use.
71701B
26.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH
Detach the 2 claws on the top of the board.
Pull up the board to detach the 2 claws on the bottom of the board and remove it.
71940A
27.REMOVE REAR SEAT HEADREST ASSEMBLY
71931B
28.REMOVE REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY
Detach the 4 claws and remove the 2 supports.
29.REMOVE SEATBACK COVER WITH PAD
Remove the hog rings.
w/ Rear Seat Side Airbag:
Remove the cap nut and seatback cover bracket from the seat frame.
Remove the side airbag wire harness through the hole in the seatback.
w/ Seat Heater System:
Cut the cable tie and disconnect the seatback heater wire harness.
Remove the seatback heater wire harness through the hole in the seatback.
Remove the seatback cover with pad.
71077S
30.REMOVE REAR SEPARATE TYPE SEATBACK COVER
w/ Rear Seat Side Airbag:
Disconnect the seatback cover bracket from the seatback pad.
Remove the hog rings and rear seatback cover.
87510Q
31.REMOVE REAR SEATBACK HEATER ASSEMBLY (w/ Seat Heater System)
Cut off the tack pins which fasten the seatback heater to the seatback cover, and then remove the seatback heater from the seatback cover.
71834D
32.REMOVE REAR SEAT RECLINING COVER LH
Remove the screw.
Detach the claw and remove the cover.
71833D
33.REMOVE REAR SEAT RECLINING COVER RH
Remove the screw.
Detach the claw and remove the cover.
71834B
34.REMOVE REAR NO. 2 SEAT RECLINING COVER LH
Remove the screw.
Detach the clamp and remove the cover.
71833A
35.REMOVE REAR NO. 1 SEAT RECLINING COVER RH
Remove the screw.
Detach the claw and remove the cover.
72570B
36.REMOVE RECLINING ADJUSTING CABLE ASSEMBLY RH
Detach the 2 cable clamps and disconnect the cable.
Detach the clamp and remove the adjusting cable.
78910
37.REMOVE NO. 1 FOLD SEAT LOCK CONTROL CABLE ASSEMBLY
Detach the 2 cable clamps and disconnect the cable.
Detach the clamp and remove the lock control cable.
71017
38.REMOVE REAR SEATBACK FRAME SUB-ASSEMBLY RH
Using a T40 "TORX" socket, remove the 4 bolts.
Remove the seatback frame.
78091
39.REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY
Detach the 2 cable clamps and disconnect the 2 cables.
Remove the 2 fold seat lock control cables.
72620B
40.REMOVE REAR NO. 1 SEAT LOCK CABLE ASSEMBLY
Remove the 2 nuts and lower seat track bracket.
Remove the 2 nuts and lower seat track bracket.
Detach the 3 cable clamps and disconnect the 3 cables.
Detach the clamp and remove the seat lock cable.
71385B
41.REMOVE REAR SEAT CUSHION HOLDER BRACKET RH (w/ Seat Heater System)
Disconnect the seat wire connector.
Remove the 2 screws and holder bracket.
87501A
42.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY RH (w/ Seat Heater System)
Detach the 2 claws and remove the seat heater control.
73380C
43.REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
71015A
44.REMOVE REAR SEAT CUSHION FRAME SUB-ASSEMBLY RH
Using a T40 "TORX" socket, remove the bolt.
Remove the 5 nuts and seat cushion frame.
72663
45.REMOVE REAR NO. 1 SEAT LOCK CONTROL LEVER
Remove the bolt and lock control lever.