Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
72329
1.REMOVE SEAT ADJUSTER BOLT COVER
Using a screwdriver, detach the 2 claws and remove the cover.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
72526C
2.REMOVE NO. 2 RECLINING ADJUSTER RELEASE HANDLE LH
Remove the screw and release handle.
71844B
3.REMOVE RECLINING ADJUSTER COVER LH
Remove the screw.
Detach the 3 claws in the order shown in the illustration, and then remove the cover.
71843C
4.REMOVE RECLINING ADJUSTER COVER RH
Remove the screw.
Detach the 5 claws in the order shown in the illustration, and then remove the cover.
79957
5.REMOVE REAR SEAT REAR BRACKET COVER REAR
Detach the 2 claws and cover.
79384
6.REMOVE REAR NO. 3 SEAT LEG COVER LH
Using a screwdriver, remove the spring of the seat stay ball-joint.
Disconnect the seat stay.
Remove the 2 screws and cover.
79246A
7.REMOVE NO. 2 SEAT LEG COVER NO. 2
Remove the screw and seat leg cover.
72906
8.REMOVE 3RD SEAT LINK SUB-ASSEMBLY LH
Remove the bolt, nut and seat link.
72918
9.REMOVE 3RD SEAT CUSHION LOCK COVER
Detach the 4 claws and remove the 2 covers.
72928
10.REMOVE REAR SEAT CUSHION UNDER COVER LH
Detach the 16 claws.
Remove the 7 screws and cover.
79382
11.REMOVE NO. 3 SEAT FRONT BRACKET COVER LH
Detach the 4 claws and remove the cover.
79367
12.REMOVE NO. 3 SEAT LEG COVER NO. 2
Remove the 2 screws.
Detach the 4 claws and remove the cover.
72666B
13.REMOVE REAR SEAT LOCK COVER LH
Remove the 2 screws.
Detach the 2 clamps and remove the 2 covers.
72345
14.REMOVE SEAT STAND FRAME CAP
Using a screwdriver, detach the 2 claws and remove the stand frame cap.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
72690C
15.REMOVE SEAT CUSHION LOCK RELEASE LEVER ASSEMBLY LH
Remove the screw.
Detach the claw and remove the release lever.
Detach the cable clamp and disconnect the cable.
73307
16.REMOVE REAR CENTER SEAT INNER BELT LH (w/ Rear Center Seat Headrest)
73302
17.REMOVE REAR CENTER SEAT INNER BELT RH (w/ Rear Center Seat Headrest)
73580A
18.REMOVE REAR NO. 2 SEAT INNER BELT SUB-ASSEMBLY
71887C
19.REMOVE REAR SEAT CUSHION CARPET
Cut off the tack pins which fasten the seat cushion carpet to the seat cushion pad, and then remove the seat cushion carpet from the seat cushion pad.
73949
20.REMOVE CAP
Detach the 4 claws and remove the 2 caps.
66992
21.REMOVE NO. 2 BOTTLE HOLDER
Remove the 2 screws and No. 2 bottle holder.
22.REMOVE SEAT CUSHION COVER WITH PAD
79345A
23.REMOVE NO. 3 SEAT CUSHION PAD LH
79032
24.REMOVE NO. 3 SEAT CUSHION COVER SUB-ASSEMBLY LH
w/o Bottle Holder:
Remove the hog rings.
Detach the fastening tape and remove the seat cushion cover.
| *1 | Fastening Tape |
w/ Bottle Holder:
Remove the hog rings.
Detach the 3 fastening tapes and remove the seat cushion cover.
| *1 | Fastening Tape |
79029A
25.REMOVE NO. 2 SEAT STAY SUB-ASSEMBLY
Remove the bolt and seat stay.
78930
26.REMOVE NO. 3 FOLD SEAT LOCK CONTROL CABLE ASSEMBLY
Detach the 2 cable clamps and disconnect the 2 cables.
Detach the 2 clamps and remove the cable.
79393
27.REMOVE REAR NO. 2 SEATBACK CUSHION
Remove the screw and seatback cushion.
72668A
28.REMOVE REAR LOWER SEATBACK LOCK BEZEL
Detach the 3 claws and clip, and then remove the seatback lock bezel.
72779
29.REMOVE REAR SEAT HINGE PAWL GUIDE
Detach the 5 claws and remove the guide.
72779A
30.REMOVE REAR SEAT HINGE PAWL GUIDE
Remove the screw and guide.
71970
31.REMOVE REAR SEAT HEADREST ASSEMBLY (w/ Folding Headrest)
While releasing the lock inside the headrest support with a screwdriver, remove the headrest.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
71970
32.REMOVE REAR SEAT HEADREST ASSEMBLY (w/o Folding Headrest)
71984A
33.REMOVE REAR SEAT HEADREST HANDLE
Remove the snap ring and headrest handle.
34.REMOVE SEATBACK COVER WITH PAD
LH Side:
w/ Rear Center Headrest:
Open the fastener.
Detach the 2 hooks.
Pull out the center headrest storage bag.
Remove the rear seat protector.
Detach the 8 claws and remove the 4 headrest supports.
w/o Rear Center Headrest:
Detach the hook.
Remove the rear seat protector.
Detach the 4 claws and remove the 2 headrest supports.
RH Side:
Detach the hook.
Remove the rear seat protector.
Detach the 4 claws and remove the 2 headrest supports.
Remove the hog ring and seatback cover with pad.
79034
35.REMOVE NO. 3 SEATBACK COVER SUB-ASSEMBLY LH
Remove the hog rings and seatback cover.
71879A
36.REMOVE REAR INNER SEAT RECLINING COVER LH
Remove the screw.
Detach the claw and remove the cover.
71878A
37.REMOVE REAR INNER SEAT RECLINING COVER RH
Remove the screw.
Detach the claw and remove the cover.
72695A
38.REMOVE REAR SEAT LOCK CONTROL CABLE
Detach the 2 cable clamps and disconnect the 2 cables.
Detach the 2 clamps and remove the lock control cable.
72680A
39.REMOVE REAR SEATBACK LOCK STRIKER ASSEMBLY LH
Remove the 2 nuts and lock striker.
72997C
40.REMOVE REAR NO. 2 SEATBACK COVER LH
Detach the 3 claws and remove the cover.
72616A
41.REMOVE REAR SEATBACK LOCK STRIKER COVER LH
Detach the 2 clamps and remove the cover.
72507D
42.REMOVE NO. 2 SEAT RECLINING RELEASE HANDLE SUB-ASSEMBLY
Remove the bolt and release handle.