Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
72329
1.REMOVE SEAT ADJUSTER BOLT COVER
Using a screwdriver, detach the 2 claws and remove the cover.
Tape the screwdriver tip before use.
72526A
2.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
Remove the screw and release handle.
71834G
3.REMOVE REAR NO. 1 SEAT RECLINING COVER LH
Remove the 2 screws.
Detach the 3 claws in the order shown in the illustration, and then remove the cover.
71833A
4.REMOVE REAR NO. 1 SEAT RECLINING COVER RH
Remove the 2 screws.
Detach the 4 claws and remove the cover.
72266
5.REMOVE UPPER SEAT TRACK RAIL COVER LH
Using a screwdriver, detach the 2 claws and remove the cover.
Tape the screwdriver tip before use.
72265
6.REMOVE UPPER SEAT TRACK RAIL COVER RH
Using a screwdriver, detach the 2 claws and remove the cover.
Tape the screwdriver tip before use.
79951
7.REMOVE NO. 1 SEAT CUSHION COVER
Detach the 4 claws and remove the 2 covers.
79965
8.REMOVE REAR NO. 2 SEAT LEG SIDE COVER
Remove the 4 screws and detach the 4 claws.
Remove the bolt that is securing the fold seat stopper band and remove the seat leg side cover together with the fold seat stopper band.
78950C
9.REMOVE FOLD SEAT STOPPER BAND ASSEMBLY
Remove the fold seat stopper band from the seat leg side cover.
71777
10.REMOVE REAR SEAT SIDE HINGE FEMALE COVER
Using a screwdriver, detach the 6 claws and remove the 2 covers.
Tape the screwdriver tip before use.
71779
11.REMOVE REAR SEAT SIDE HINGE MALE COVER LH
Detach the clip and remove the cover.
71778
12.REMOVE REAR SEAT SIDE HINGE MALE COVER RH
Detach the clip and remove the cover.
71469
13.REMOVE REAR NO. 2 SEAT PROTECTOR
w/ Rear Seat Side Airbag:
Detach the claw and remove the wire harness connector.
w/ Seat Heater System:
Detach the claw and remove the wire harness connector.
Using a clip remover, remove the clip.
Detach the claw and remove the seat protector from the seat hinge.
Detach the 2 claws, open the protector and remove wire harness.
71302B
14.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
w/ Rear Seat Side Airbag:
Detach the wire harness clamp.
w/ Seat Heater System:
Detach the wire harness clamp.
Remove the 2 nuts and hinge.
Detach the cable clamp and disconnect the cable.
71301B
15.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH
Remove the 2 nuts and hinge.
73178B
16.REMOVE SEAT BELT ANCHOR COVER CAP
Detach the claw and open the cap.
Remove the screw and anchor cover cap.
71369B
17.REMOVE REAR SEATBACK STAY COVER LH
Remove the screw.
Detach the 2 claws and remove the cover.
76974E
18.REMOVE REAR UNDER SIDE COVER LH
Detach the 10 claws.
Remove the 5 screws.
Detach the 2 clips and 2 claws, and remove the cover.
79123
19.REMOVE NO. 1 SEAT CUSHION PLATE
Detach the 3 claws and remove the seat cushion plate.
72995
20.REMOVE REAR SEAT CUSHION COVER RH
Remove the 4 screws.
Detach the 2 claws and remove the cover.
78956
21.REMOVE REAR SEAT UNDER TRAY COVER LH
Remove the 2 screws.
Detach the 4 claws and remove the cover.
72203
22.REMOVE REAR SEAT TRACK HANDLE SUB-ASSEMBLY
Remove the 2 screws and seat track handle.
Detach the 2 cable clamps and disconnect the 2 cables.
Detach the cable clamp and disconnect the cable.
78091A
23.REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY
73390C
24.REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
73320A
25.DISCONNECT NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH
26.REMOVE SEAT CUSHION COVER WITH PAD
w/ Rear Seat Side Airbag:
Detach the side airbag wire harness clamps.
Remove the side airbag wire harness through the hole in the seat cushion.
w/ Seat Heater System:
Disconnect the 2 seat heater connectors.
Remove the seatback heater wire harness through the hole in the seat cushion.
Remove the seat cushion cover with pad.
71076S
27.REMOVE REAR SEPARATE TYPE SEAT CUSHION COVER
Detach the 3 pieces of fastening tape.
Remove the hog rings and cover.
87510P
28.REMOVE REAR SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)
Cut off the tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.
72997B
29.REMOVE REAR SEATBACK COVER
Using a screwdriver, detach the 4 claws and remove the cover.
Tape the screwdriver tip before use.
71702B
30.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY LH
w/ Center Armrest:
Detach the 2 claws on the top of the board.
Pull up the board to detach the 2 claws on the bottom of the board and remove it.
w/o Center Armrest:
Detach the 3 claws on the top of the board.
Pull up the board to detach the 3 claws on the bottom of the board and remove it.
71940A
31.REMOVE REAR SEAT HEADREST ASSEMBLY
71931B
32.REMOVE REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY
w/ Center Armrest:
Detach the 4 claws and remove the 2 supports.
w/o Center Armrest:
Detach the 8 claws and remove the 4 supports.
73237
33.REMOVE SHOULDER BELT ANCHOR COVER
Using a screwdriver, detach the 2 claws and remove the cover.
Tape the screwdriver tip before use.
73174A
34.REMOVE REAR SEAT BELT HOLE COVER LH
Remove the screw.
Detach the 4 claws and remove the cover.
35.REMOVE SEATBACK COVER WITH PAD
w/ Center Armrest:
Remove the hog rings.
w/o Center Armrest:
Remove the hog rings.
w/ Rear Seat Side Airbag:
Remove the cap nut and seatback cover bracket from the seat frame.
Remove the side airbag wire harness through the hole in the seatback.
w/ Seat Heater System:
Cut the cable tie and disconnect the seatback heater wire harness.
Remove the seatback heater wire harness through the hole in the seatback.
w/ Center Armrest:
Pull the seat belt into the inside of the seat.
w/o Center Armrest:
Pull the seat belt into the inside of the seat.
Remove the seatback cover with pad.
71078S
36.REMOVE REAR SEPARATE TYPE SEATBACK COVER
w/ Rear Seat Side Airbag:
Disconnect the seatback cover bracket from the seatback pad.
w/ Center Armrest:
Remove the hog rings and rear seatback cover.
w/o Center Armrest:
Remove the hog rings and rear seatback cover.
87510Q
37.REMOVE REAR SEATBACK HEATER ASSEMBLY (w/ Seat Heater System)
Cut off the tack pins which fasten the seatback heater to the seatback cover, and then remove the seatback heater from the seatback cover.
72569
38.REMOVE SEATBACK STOPPER PLATE
w/ Center Armrest:
Using a T40 "TORX" socket, remove the 2 bolts.
Remove the bolt and stopper plate.
Remove the bush from the stopper plate.
w/o Center Armrest:
Using a T40 "TORX" socket, remove the 2 bolts.
Remove the bolt and stopper plate.
Remove the bush from the stopper plate.
72830
39.REMOVE REAR CENTER SEAT ARMREST ASSEMBLY (w/ Center Armrest)
Using a T40 "TORX" socket, remove the 2 bolts and center seat armrest.
71960B
40.REMOVE REAR CENTER SEAT HEADREST ASSEMBLY (w/ Center Armrest)
72832A
41.REMOVE NO. 1 SEAT ARMREST PLATE (w/ Center Armrest)
Using a moulding remover, detach the 4 clips and 2 claws, and then remove the 2 armrest plates.
66990
42.REMOVE CUP HOLDER ASSEMBLY (w/ Center Armrest)
Remove the 2 screws.
Using a moulding remover, detach the 2 clips and remove the cup holder.
71834D
43.REMOVE REAR SEAT RECLINING COVER LH
Remove the screw.
Detach the claw and remove the cover.
71834B
44.REMOVE REAR NO. 2 SEAT RECLINING COVER LH
Remove the screw.
Detach the clamp and remove the cover.
71833A
45.REMOVE REAR NO. 1 SEAT RECLINING COVER RH
Remove the screw.
Detach the claw and remove the cover.
71379B
46.REMOVE REAR SEATBACK HINGE COVER LH
Remove the screw.
Detach the claw and remove the cover.
71099
47.REMOVE REAR LOWER SEATBACK COVER SUB-ASSEMBLY LH
Remove the 4 screws.
Detach the 4 claws and remove the cover.
73375B
48.REMOVE REAR SEAT SHOULDER BELT HOLE COVER LH
73320A
49.REMOVE NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH
72580A
50.REMOVE RECLINING ADJUSTING CABLE ASSEMBLY LH
Detach the 2 cable clamps and disconnect the cable.
Detach the clamp and remove the adjusting cable.
78920
51.REMOVE NO. 2 FOLD SEAT LOCK CONTROL CABLE ASSEMBLY
Detach the 2 cable clamps and disconnect the cable.
Detach the clamp and remove the lock control cable.
71018
52.REMOVE REAR SEATBACK FRAME SUB-ASSEMBLY LH
LH Side:
Using a T40 "TORX" socket, remove the 2 bolts.
RH Side:
Using a T55 "TORX" socket, remove the 2 bolts.
Remove the seatback frame sub-assembly.
Remove the lower seatback cover.
78091
53.REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY
Detach the 2 cable clamps and disconnect the 2 cables.
Remove the 2 fold seat lock cables.
72620B
54.REMOVE REAR NO. 1 SEAT LOCK CABLE ASSEMBLY
Remove the 2 nuts and lower seat track bracket.
Cut the cable tie and disconnect the cable.
Detach the 3 cable clamps and disconnect the 3 cables.
Detach the clamp and remove the seat lock cable.
71386A
55.REMOVE REAR SEAT CUSHION HOLDER BRACKET LH (w/ Seat Heater System)
Disconnect the seat wire connector.
Remove the 2 screws and holder bracket.
87501B
56.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System)
Detach the 2 claws and remove the seat heater control.
73390A
57.REMOVE REAR SEAT INNER BELT ASSEMBLY
79120B
58.REMOVE NO. 1 SEAT LEG ASSEMBLY LH
Using a T40 "TORX" socket, remove the 2 bolts and seat leg assembly.
71016A
59.REMOVE REAR SEAT CUSHION FRAME SUB-ASSEMBLY LH
Using a T40 "TORX" socket, remove the bolt.
Remove the 5 nuts and seat cushion frame.
72664
60.REMOVE REAR SEAT LOCK CONTROL LEVER LH
Remove the bolt and lock control lever.