Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL SEAT HEATER SWITCH
Attach the 2 claws to install the seat heater switch.
2.INSTALL SUSPENSION CONTROL SWITCH
Attach the 4 claws to install the suspension control switch.
Connect the 2 connectors.
Attach the wire harness clamp.
3.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
4.INSTALL CONSOLE CUP HOLDER BOX SUB-ASSEMBLY
5.INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
6.INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
7.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
8.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
9.INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION
10.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
11.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
12.INSPECT SEAT HEATER SYSTEM
Check the seat heater operation.
Turn the ignition switch on (IG).
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.
13.INSPECT CLIMATE CONTROL SEAT SYSTEM (w/ Climate Control Seat System)
Check the climate control seat operation.
When the climate control seat switch is turned on, check that the seat heater and blower operate based on the seat temperature.
If the seat temperature increases as a result of the seat heater operation, check that the seat heater operation stops and the blower operation continues.
Based on the cabin temperature, seat temperature, etc., the seat heater operation time varies.