Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM2660E _58 Vehicle Interior _052846 SEAT BELT _0255653 FRONT SEAT OUTER BELT ASSEMBLY G

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 73220 1.INSPECT FRONT SEAT OUTER BELT ASSEMBLY

B121581E10
0.917,0.198 1.24,0.5 0.323,0.302 10 false 45°

CAUTION:

Do not disassemble the retractor.


a.

Before installing the seat belt, check the ELR.

i.

When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks. If the operation is not as specified, replace the seat belt assembly.



b.
B163242

Check the tension reducer operation.

B449798E01
1.708,2.094 2.073,1.75 true 2.292,1.74 2.688,2.094 true 0.177,0.073 2.656,0.427 2.479,0.354 10 false Component without harness connected: (Front Seat Outer Belt) 1.438,0.823 3.188,1.083 1.75,0.26 10 false Tension Reducer Connector 1.573,2.094 1.76,2.281 0.188,0.188 10 false L 2.75,2.104 2.938,2.292 0.188,0.188 10 false IG 1.438,2.385 3.188,2.646 1.75,0.26 10 false Pretensioner Connector* 4.073,2.385 6.271,2.615 2.198,0.229 10 false *: Do not apply battery voltage

NOTICE:

Do not apply battery voltage to the pretensioner connector.


i.

Connect the battery positive (+) lead to terminal 1 (IG) of the tension reducer connector and the negative (-) lead to terminal 2 (L).


ii.

Check that an operating sound is heard when the magnetized solenoid is attracting the plunger.


iii.

Pull out the seat belt and let it retract. Listen to the operating sound.


iv.

Pull out the seat belt again, disconnect the battery negative (-) lead and let it retract. Listen to the operating sound again and check that the operating sound volume has increased.

If the result is not as specified, replace the outer belt assembly.