Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR NO. 2 SEAT ASSEMBLY
Remove the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>REMOVAL).
58574A
2.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
51775
3.REMOVE REAR STEP COVER
67918E
4.REMOVE REAR DOOR SCUFF PLATE LH
71866B
5.REMOVE REAR NO. 2 SEAT COVER BEZEL
62520P
6.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
When installing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.
Detach the 3 claws and remove the cover.
Remove the bolt and disconnect the rear seat outer belt floor anchor.
for LH Side:
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor LH.
for RH Side:
Detach the 3 claws and remove the cover.
Remove the bolt and disconnect the rear seat outer belt floor anchor RH.
Remove the clip and bolt.
Detach the 18 clips and 2 claws.
w/o Rear Air Conditioning System:
Disconnect the rear seat lock control lever cable and then remove the quarter trim panel.
w/ Rear Air Conditioning System:
Disconnect the thermistor connector and rear seat lock control lever cable, and then remove the quarter trim panel.
73570
7.REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt and disconnect the seat belt shoulder anchor.
Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.
Tape the screwdriver tip before use.
Remove the bolt and seat belt shoulder anchor.
Remove the bolt and rear No. 2 seat outer belt.