89120
1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR (SOLAR SENSOR)
Connect the battery positive (+) lead to terminal 6 and the negative (-) lead to terminal 3, then measure the according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (TSL) - 3 (CLTE) | Sensor subject to electric light | 0.5 V to 3.0 V |
| 1 (TSL) - 3 (CLTE) | Sensor covered with a cloth | 0.5 V or less |
| 2 (TSR) - 3 (CLTE) | Sensor subject to electric light | 0.5 V to 3.0 V |
| 2 (TSR) - 3 (CLTE) | Sensor covered with a cloth | 0.8 V or less |
If the result is not as specified, replace the automatic light control sensor (solar sensor).
As the inspection light is moved away from the sensor, the voltage increases.
Use an incandescent lamp for inspection. Bring it within 30 cm (11.8 in.) of the A/C solar sensor.