Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1GR-FE)
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255681 COMPRESSOR(for 1GR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1GR-FE)  REASSEMBLY  


PROCEDURE

Hide 88410 1.INSTALL MAGNET CLUTCH ASSEMBLY

E168158

a.

Install the magnet clutch stator with the parts shown in the illustration matched.


b.
I032461

Using a snap ring expander, install a new snap ring with the chamfered side facing up.


c.

Connect the connector.


d.
I031582

Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.

NOTICE:

Do not damage the seal cover of the bearing when installing the snap ring.



e.

Install the compressor washer(s) and magnet clutch hub.

NOTICE:

Do not change the combination of the compressor washer(s) used before disassembly.



f.
E168159E02
0.625,0.708 0.958,0.708 false 0.25,0.625 0.625,0.813 0.375,0.188 10 false SST

Using SST, hold the magnet clutch hub and install the bolt.

SST
09985-00270  

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:

Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.



Hide 2.INSTALL COOLER BRACKET

E168155

a.

Install the cooler bracket with the screw.


b.

Attach the clamp.


Hide 3.INSPECT MAGNET CLUTCH CLEARANCE

E168160E04
0.125,0.063 2.594,0.448 2.469,0.385 10 false Component without harness connected: (Magnet Clutch) 2.76,3.969 3.26,4.167 0.5,0.198 10 false Battery

a.

Clamp the cooler compressor in a vise.


b.

Set the dial indicator to the magnet clutch hub.


c.

Connect the battery positive lead to terminal 3 of the magnet clutch connector and the negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.

Standard clearance:

0.35 to 0.60 mm (0.014 to 0.024 in.)


If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using compressor washers to obtain the standard clearance.

Compressor washer thickness:

0.1 mm (0.004 in.)

0.3 mm (0.012 in.)

0.5 mm (0.020 in.)


NOTICE:

Adjustment should be performed with 3 or fewer magnet clutch washers.



d.

Remove the cooler compressor from the vise.