Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) › from 2015.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255699 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  IG Power Source Circuit  


DESCRIPTION

The main power source is supplied to the air conditioning amplifier assembly when the ignition switch is ON. The power source is used for operating the air conditioning amplifier assembly and servo motor, etc.

WIRING DIAGRAM

w/ Rear Heater:


E315724E17
4.875,1.75 5.333,1.948 0.458,0.198 10 false E36 4.875,1.917 7.115,2.167 2.24,0.25 10 false Air Conditioning Amplifier Assembly 5.563,0.563 6.021,0.76 0.458,0.198 10 false IG+ 5.563,1.281 6.021,1.479 0.458,0.198 10 false GND 5.229,1.167 5.688,1.365 0.458,0.198 10 false 1 5.292,0.469 5.75,0.667 0.458,0.198 10 false 5 3.979,0.75 4.833,0.969 0.854,0.219 10 false A/C COMP 1.656,0.573 2.656,0.833 1,0.26 10 false from IG1 Relay


w/o Rear Heater:


E315724E18
4.896,1.729 5.24,1.938 0.344,0.208 10 false E81 4.896,1.906 7.115,2.156 2.219,0.25 10 false Air Conditioning Amplifier Assembly 5.563,0.563 6.021,0.76 0.458,0.198 10 false IG+ 5.563,1.281 6.021,1.479 0.458,0.198 10 false GND 5.229,1.167 5.688,1.365 0.458,0.198 10 false 14 5.292,0.469 5.75,0.667 0.458,0.198 10 false 1 3.979,0.74 4.813,0.938 0.833,0.198 10 false A/C COMP 1.688,0.573 2.646,0.823 0.958,0.25 10 false from IG1 Relay


CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BATTERY AND BODY GROUND)
a.
U156774E03
1.146,0.458 1.375,0.458 1.375,0.458 1.542,1.146 false 2.542,0.708 2.313,0.708 2.313,0.708 2.146,1.167 false 0.094,0.073 0.313,0.24 0.219,0.167 10 false *a 0.854,0.375 1.125,0.542 0.271,0.167 10 false IG+ 2.615,0.615 2.99,0.781 0.375,0.167 10 false GND 0.615,1.219 0.99,1.385 0.375,0.167 10 false E36

w/ Rear Heater:

i.

Disconnect the air conditioning amplifier assembly connector.


ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E36-1 (GND) - Body ground Always Below 1 Ω



iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
E36-5 (IG+) - Body ground Ignition switch off Below 1 V
E36-5 (IG+) - Body ground Ignition switch ON 11 to 14 V




b.
U166420E01
1.562,0.285 1.986,0.537 0.424,0.253 10 E81 0.043,0.027 0.467,0.280 0.424,0.253 10 *a 3.048,0.91 3.346,1.085 0.298,0.175 10 IG+ 0.472,0.475 0.820,0.652 0.349,0.177 10 GND 0.882,0.555 1.157,0.555 1.157,0.555 1.377,1.283 false 3.006,1.006 2.731,1.006 2.731,1.006 2.655,1.271 false

w/o Rear Heater:

i.

Disconnect the air conditioning amplifier assembly connector.


ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E81-14 (GND) - Body ground Always Below 1 Ω



iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
E81-1 (IG+) - Body ground Ignition switch off Below 1 V
E81-1 (IG+) - Body ground Ignition switch ON 11 to 14 V




Text in Illustration
*a Rear view of wire harness connector
(to Air Conditioning Amplifier Assembly)


OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR