The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even when turning the ignition switch off and is used for diagnostic trouble code memory, etc.
w/ Rear Heater:
w/o Rear Heater:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
w/ Rear Heater:
Disconnect the air conditioning amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E35-6 (E1) - Body ground | Always | 11 to 14 V |
| E36-1 (GND) - Body ground | Always | 11 to 14 V |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E36-6 (+B1) - Body ground | Always | 11 to 14 V |
| E36-7 (+B2) - Body ground | Always | 11 to 14 V |
w/o Rear Heater:
Disconnect the air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E81-14 (GND) - Body ground | Always | 11 to 14 V |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E81-21 (+B1) - Body ground | Always | 11 to 14 V |
| *a | Rear view of wire harness connector
(to Air Conditioning Amplifier Assembly) |
OK
NG