Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255699 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) D

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  ACTUATOR CHECK  


ACTUATOR CHECK


a.

Start the engine and warm it up.

E349485E01
0.26,0.146 0.573,0.344 0.313,0.198 10 false *A 3.896,0.198 4.208,0.396 0.313,0.198 10 false *B


b.

Perform the indicator check (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>CHECK MODE PROCEDURE).

Text in Illustration
*A w/ Navigation System
*B w/o Navigation System


c.

Press the "Recirculation/Fresh" switch.

E349490E01
1.469,0.625 1.677,0.208 1.677,0.208 1.781,0.208 false 5.063,1.198 5.521,0.854 5.521,0.854 5.646,0.854 false 0.146,0.104 0.458,0.302 0.313,0.198 10 false *A 3.938,0.125 4.25,0.323 0.313,0.198 10 false *B 1.833,0.135 2.146,0.333 0.313,0.198 10 false *1 5.729,0.771 6.042,0.969 0.313,0.198 10 false *1


d.

By performing the actuator check, each damper, motor, and relay are automatically operated at 1 second intervals in a continuous cycle from step No. 1 to No. 10. During this operation, check the temperature and airflow indicated on the display as well as by hand.



HINT:
·

If a slower display is desired, press the driver temperature up switch to stop the automatic display. The display changes to step operation display mode which allows the display to be changed 1 step for each press of the switch.

·

The buzzer sounds when the display code changes.

·

Codes are displayed from smaller to larger numbers in order.

·

To cancel the check mode, press the "OFF" switch.

·

Use the same procedures for the LHD vehicle and RHD vehicle.

·

The procedures listed below are for the LHD vehicle.



Text in Illustration
*A w/ Navigation System
*B w/o Navigation System
*1 Code Display

Front Air Conditioning Unit
Step No. Display Code Conditions
Blower Level Air Mix Damper
Dr. Pa.
Air Mix Damper
FrRr
Dr. Pa.
Airflow Vent
Dr. Pa.
DEF Mode
Airflow Vent
FrRr
Air Inlet Cool Air Bypass Damper Compressor
1 0 0 0% 0% FACE FACE FRESH -14% OFF
2 1 1
3 2 17 RECIRCULATION/FRESH ON
4 3 17 RECIRCULATION 113.0%
5 4 17 50% 50% B/L B/L
6 5 17
7 6 17 FOOT FOOT FRESH
8 7 17 100% 100% FOOT
9 8 17 F/D
10 9 31 DEF 113.5%

Rear Air Conditioning Unit
Step No. Display Code Conditions
Rear Blower Level Rear Air Mix Damper
Dr. Pa.
Rear Airflow Vent
Dr. Pa.
Rear Magnetic Valve
1 0 0 0% FACE OFF
2 1 3
3 2 17 ON
4 3 17
5 4 17 50% B/L OFF
6 5 17
7 6 17 FOOT
8 7 17 100%
9 8 17
10 9 31