Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1UR-FE)
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255705 COMPRESSOR(for 1UR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1UR-FE)  REASSEMBLY  


PROCEDURE

Hide 88410 1.INSTALL MAGNET CLUTCH ASSEMBLY

I104345

a.

Install the magnet clutch stator with the parts shown in the illustration matched.


b.
I032461

Using a snap ring expander, install a new snap ring with the chamfered side facing up.


c.

Connect the connector.


d.
I031582

Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.

NOTICE:

Do not damage the seal cover of the bearing when installing the snap ring.



e.

Install the compressor washer(s) and magnet clutch hub.

NOTICE:

Do not change the combination of the compressor washer(s) used before disassembly.



f.
I104346E01
0.374,0.901 0.675,1.045 0.301,0.145 10 SST 0.771,0.986 1.145,1.125 false

Using SST, hold the magnet clutch hub and install the bolt.

SST
09985-00270  

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:

Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.



Hide 2.INSTALL COOLER BRACKET

I104342E01
3.171,0.265 3.360,0.476 0.188,0.211 10 *1 2.008,0.824 2.564,0.346 2.564,0.346 3.138,0.346 false

a.

Install the cooler bracket with the screw.


b.

Attach the clamp.

Text in Illustration
*1 Cooler Bracket


Hide 3.INSPECT MAGNET CLUTCH CLEARANCE

I104347E04
0.099,0.046 0.301,0.239 0.202,0.193 10 *a 2.336,3.578 2.538,3.771 0.202,0.193 10 *1 2.509,3.671 2.761,3.671 false

a.

Clamp the cooler compressor in a vise.


b.

Set the dial indicator to the magnet clutch hub.


c.

Connect the battery positive lead to terminal 3 of the magnet clutch connector and the negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.

Standard clearance:

0.35 to 0.60 mm (0.014 to 0.024 in.)


If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using compressor washers to obtain the standard clearance.

Compressor washer thickness:

0.1 mm (0.004 in.)

0.3 mm (0.012 in.)

0.5 mm (0.020 in.)


NOTICE:

Adjustment should be performed with 3 or fewer magnet clutch washers.



d.

Remove the cooler compressor from the vise.

Text in Illustration
*1 Battery
*a Component without harness connected
(Magnet Clutch Assembly)