Home › Vehicle Interior › HEATING / AIR CONDITIONING › HEATER SWITCH › from 2015.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255709 HEATER SWITCH G

HEATING / AIR CONDITIONING  HEATER SWITCH  INSPECTION  


PROCEDURE

Hide 84453 1.INSPECT IDLE UP SWITCH

E166833E05
0.134,0.034 0.307,0.215 0.173,0.180 10 *a 0.897,1.65 1.174,1.837 0.277,0.187 10 SW 2.319,1.65 2.463,1.837 0.144,0.187 10 E 1.361,1.65 1.715,1.837 0.354,0.187 10 ILL+ 1.804,1.65 2.157,1.837 0.354,0.187 10 ILL- 1.393,1.203 1.013,1.519 false 1.013,1.519 1.013,1.65 false 1.627,1.214 1.493,1.377 false 1.493,1.377 1.493,1.65 false 1.838,1.205 1.915,1.369 false 1.915,1.369 1.915,1.65 false 2.018,1.21 2.376,1.368 false 2.376,1.368 2.376,1.65 false

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 (SW) - 3 (E) Idle up switch off 10 kΩ or higher
Idle up switch on Below 1 Ω



b.

Apply battery voltage to the connector and check the LED illumination.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 4 (ILL-)
LED illuminates


Text in Illustration
*a Component without harness connected
(Idle Up Switch)

If the result is not as specified, there may be a malfunction in the idle up switch.