1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
71200S
2.REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)
Remove the front seat assembly LH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL).
71200S
3.REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)
Remove the front seat assembly LH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL).
55449C
4.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 7 claws and remove the panel cushion.
55403C
5.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
Remove the clip.
Remove the screw.
Detach the 8 claws.
Remove the panel pad and disconnect the connectors and 2 clamps.
55448A
6.REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 7 claws and remove the panel cushion.
55402C
7.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
Remove the clip.
Remove the screw.
Detach the 7 claws and remove the panel.
33504F
8.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Twist the shift lever knob in the direction indicated by the arrow and remove it.
55406B
9.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Detach the 7 claws.
Disconnect the connectors and remove the panel.
58805C
10.REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Detach the 9 claws and remove the panel.
58803C
11.REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY
Detach the 4 claws and remove the box.
58804A
12.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
Detach the 14 claws.
Disconnect the connectors and remove the console panel.
88891H
13.REMOVE NO. 1 COOLER COVER
Detach the clamp on the lower part of the cooler cover, and then pull the cooler cover upward to remove it.
58903A
14.REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 8 claws.
Remove the end panel and disconnect the connectors and 2 clamps.
88520
15.REMOVE COOLING BOX ASSEMBLY
Remove the 4 bolts and 2 screws.
Remove the 2 bolts and disconnect the 2 cooler pipes.
Remove the 2 O-rings from the cooler pipes.
Disconnect the connector.
Detach the 2 claws and remove the cooling box.