Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY RH
55449C
2.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
Put protective tape around the No. 2 instrument panel finish panel cushion.
| *1 | Protective Tape |
Using a moulding remover, detach the 7 claws and remove the No. 2 instrument panel finish panel cushion.
55403C
3.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
Remove the clip and screw.
Detach the 8 claws.
Disconnect the connectors, detach the 2 clamps and remove the lower instrument panel pad sub-assembly.
55448A
4.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
Put protective tape around the No. 1 instrument panel finish panel cushion.
| *1 | Protective Tape |
Using a moulding remover, detach the 7 claws and remove the No. 1 instrument panel finish panel cushion.
55402C
5.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
Remove the clip and screw.
Detach the 7 claws and remove the lower instrument panel pad sub-assembly.
55406B
6.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Detach the 7 claws.
Disconnect the connectors and remove the lower center instrument cluster finish panel sub-assembly.
58834B
7.REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH
Put protective tape around the upper No. 2 console panel garnish.
Using a screwdriver, detach the 8 claws and remove the upper No. 2 console panel garnish.
Tape the screwdriver tip before use.
| *A | for Separate Seat Type | *B | for Bench Seat Type |
| *1 | Protective Tape | - | - |
58833B
8.REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH
Put protective tape around the upper No. 1 console panel garnish.
Using a screwdriver, detach the 8 claws and remove the upper No. 1 console panel garnish.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
58805C
9.REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Put protective tape around the rear upper console panel sub-assembly.
Using a moulding remover, detach the 12 claws and remove the rear upper console panel sub-assembly.
| *1 | Protective Tape | - | - |
33504F
10.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.
58804A
11.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
Put protective tape around the upper console panel sub-assembly.
Using a moulding remover, detach the 8 claws and remove the upper console panel sub-assembly.
58812A
12.REMOVE LOWER CONSOLE BOX
Remove the 2 screws and 4 bolts.
Detach the 2 claws and remove the lower console box.