Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows) › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052850 WINDOW / GLASS _0255725 POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows) J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)  All Power Window Up Functions do not Operate with Entry Lock Switch  


DESCRIPTION

When an entry lock switch is pressed and held for approximately 3 seconds: 1) the main body ECU receives a signal via the driver side door ECU, 2) the main body ECU transmits a signal to all the power window regulator motor, and 3) all the power window motors are activated to close the windows.

PROCEDURE

1.CHECK BASIC FUNCTION (ENTRY AND START SYSTEM (for Entry Function))
a.

Check that the entry lock switch operates (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>OPERATION CHECK).

OK:

Entry lock switch can lock all the doors.




OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

NG