Home › Vehicle Exterior › WINDOW / GLASS › WINDSHIELD DEICER SYSTEM › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052850 WINDOW / GLASS _0255726 WINDSHIELD DEICER SYSTEM U

WINDOW / GLASS  WINDSHIELD DEICER SYSTEM  TERMINALS OF ECU  


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (w/ Rear Heater)


U155855E05
3.927,0.177 4.188,0.354 0.26,0.177 10 false E36

a.

Disconnect the E36 air conditioning amplifier assembly connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E36-5 (IG+) - E36-1 (GND) G - W-B Power source (IG) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
E36-6 (+B1) - E36-1 (GND) R - W-B Power source Always 11 to 14 V
E36-7 (+B2) - E36-1 (GND) R - W-B Power source Always 11 to 14 V
E36-1 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the E36 air conditioning amplifier assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E36-23 (FDEF) - E36-1 (GND) GR - W-B Deicer relay Ignition switch ON and deicer switch off 11 to 14 V
Ignition switch ON and deicer switch on Below 1 V



CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (w/o Rear Heater)


U163888E02
4.104,0.073 4.375,0.25 0.271,0.177 10 false E81

a.

Disconnect the E81 air conditioning amplifier assembly connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E81-1 (IG+) - E81-14 (GND) G - W-B Power source (IG) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
E81-21 (+B1) - E81-14 (GND) R - W-B Power source Always 11 to 14 V
E81-14 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the E81 air conditioning amplifier assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E81-40 (FDEF) - E81-14 (GND) GR - W-B Deicer relay Ignition switch ON and deicer switch off 11 to 14 V
Ignition switch ON and deicer switch on Below 1 V



CHECK AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)


U164044E02
3.479,0.25 3.802,0.427 0.323,0.177 10 false F10

a.

Disconnect the F10 air conditioning control assembly connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F10-7 (IG+) - F10-1 (GND) G - W-B Power source (IG) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
F10-1 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.




MULTI-MEDIA MODULE RECEIVER ASSEMBLY (w/ Navigation System)


U166266E02
2.333,1.646 2.615,1.854 0.281,0.208 10 false F77

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F77-17 (+B1) - F77-12 (GND1) R - W-B Power source Always 11 to 14 V
F77-12 (GND1) - Body ground W-B - Body ground Ground Always Below 1 Ω
F77-15 (IG) - F77-12 (GND1) G - W-B Power source (IG) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
F77-16 (ACC1) - F77-12 (GND1) GR - W-B Power source (ACC) Ignition switch ACC 11 to 14 V
Ignition switch off Below 1 V
F77-35 (UIND) R UART communication signal - -
F77-36 (UPSW) P UART communication signal - -
F77-1 (CANH) P CAN communication signal - -
F77-2 (CANL) B CAN communication signal - -


MULTI-DISPLAY ASSEMBLY (w/ Navigation System)


U166254E02
1.813,0.083 2.073,0.25 0.26,0.167 10 false F79

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F79-12 (+B2) - F79-13 (GND1) R - BR Power source Always 11 to 14 V
F79-13 (GND1) - Body ground BR - Body ground Ground Always Below 1 Ω
F79-23 (IG) - F79-13 (GND1) G - BR Power source (IG) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
F79-24 (ACC) - F79-13 (GND1) GR - BR Power source (ACC) Ignition switch ACC 11 to 14 V
Ignition switch off Below 1 V
F79-3 (UPSW) P UART communication signal - -
F79-4 (UIND) R UART communication signal - -